go top

网络释义专业释义

  tack weld

定位焊(tack welding):装配时为了固定工 件位置进行的焊接。 16.

基于700个网页-相关网页

短语

定位焊缝 tack weld

定位焊夹具 tack-welding jig

定位焊接 tack weld

定位焊点 tack-weld ; tacked spot

定位焊盘 Capture Pad

双向定位焊片 Bidirectional align bonding sheet

定位焊焊缝 tack weld

定位焊接模式 Tack Mode

 更多收起网络短语
  • positioned weld(ing)
    tack welding

·2,447,543篇论文数据,部分数据来源于NoteExpress

新汉英大辞典

定位焊

  • positioned weld(ing); tacking
以上来源于:《新汉英大辞典》

双语例句

  • 定位焊应与正式焊接的焊接工艺相同。

    Tack weld shall be the same with welding process of formal welding.

    youdao

  • 不锈钢管件的定位焊起弧和结尾处应圆滑过渡,焊道不能太高,必须保证熔合良好,以防产生未焊透、夹渣等缺陷。

    The positioning welding stainless steel pipe shall be smooth transition arc and weld end, can not be too high, must ensure good fusion, produce unweld, slag and other defects in case.

    youdao

  • 在电路板的焊盘上开设缺口,该缺口与定位孔相距一定间隔,可避免出现漏锡。

    The bonding pad of the circuit board is provided with the gap, the gap and the positioning hole are spaced by certain interval to avoid tin leaking.

    youdao

更多双语例句

百科

定位焊

定位焊:为装配和固定焊件接头的位置而进行的焊接。 焊接法, 定位焊接:fastening two pieces of metal together by softening with heat and applying pressure 注意事项: (1)定位焊的起头和结尾处应圆滑,否则,易造成未焊透现象。 (2)焊接件要求预热,则定位焊时也应进行预热,其温度应与正式焊接温度相同。 (3)定位焊的电流比正常焊接的电流大10-15%。 (4)在焊缝交叉处和焊缝方向急剧变化处不要进行定位焊,确需定位焊时,宜避开该处50mm左右。 (5)定位焊缝高度不超过设计规定的焊缝的2/3,以越小越好。 (6)含碳量大于0.25%或厚度大于16mm的焊件,在低温环境下定位焊后应尽快进行打底焊,否则应采取后热缓冷措施。

详细内容

以上来源于: 百度百科
$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定