...键词：专用设备；摩擦力；剪切力；切向力；结构设计 [gap=652]Key Word: special equipment, frictional force (F), shear force (P), tangential force, structural design ...
基于954个网页-相关网页
shear force diagram [力] 剪力图
Viscous Shear Force 磨擦阻力
Largest shear Force 最大压料力
actual shear force 实际切力
turbulent shear force [流] 湍流剪切力
shear force mode 利用采剪力式
Finally,the effect of shear lag on redistribution of internal forces including shear force,bending moment,and additional bending moment due to shear lag in indeterminate box-girder bridges was studied.
最后分析剪力滞对超静定多跨连续箱梁内力及变形的影响。
参考来源 - 剪力滞对超静定箱梁结构性能的影响分析The hysteric curves of the horizontal shear force-linear displacement and that of the moment-angular displacement at the bottom of pile cap are summarized. The results show that the curve is spindle-shaped or pinched spindle-shaped.
时程分析结果表明,承台底水平剪力-水平位移、承台底弯矩-转角曲线呈纺锤状。
参考来源 - 桥梁结构非线性地震反应研究（支座摩擦·限位装置·基础非线性）The working principle of the self梒ycle ultra梖ine梒rusher used in this research is: the ore is crushed under the corporate work of pressure and shear force.
本研究课题采用的自循环超细粉碎机是以压力和剪切力相结合的施力方式破碎矿石的，矿石在被破碎时受到极大的压力和剪切力作用。
参考来源 - 攀枝花钒钛磁铁矿自循环超细粉碎研究At the later stage of mixing,the shear force decreased,and the probability of coalescence of particles increased because of effective collision.
在混炼后期,剪切力减小,粒子发生有效碰撞归并概率增大。
参考来源 - 聚合物共混相态形成过程及其理论研究进展·2,447,543篇论文数据，部分数据来源于NoteExpress
以上来源于: WordNet
Shear force distribution of round sample has good agreement with corrosion results.
片状试样表面剪切力分布与腐蚀结果一致。
Shear force is interrelating with width and thickness of plate and obliquity of knife-edge.
斜刃剪切时，剪切力的大小与板料的宽度、厚度及斜刃倾角有关。
Abstract: shear force is interrelating with width and thickness of plate and obliquity of knife-edge.
文摘：斜刃剪切时，剪切力的大小与板料的宽度、厚度及斜刃倾角有关。
应用推荐