论述了多工况倾斜冲击试验系统，该系统具有可变的冲击角度，刚度和行程长度。
The Multi-work Condition Declivitous Impact Testing System was introduced which has variable impacting angle, rigidity, and length of stroke.
适合轧钢厂轴承的工况条件。
Applicable for bearings in working conditions of rolling mill.
怠速是指发动机对外无功率输出的工况。
Engine idle speed is no power output of external conditions.
其重型设计适合于同步和高速的工况条件。
Their heavy duty design is suitable for both synchronous and high speed operation.
报导了单体电池模拟工况测试和模拟电池寿命测试；
The simulated operating condition test of cells and the simulated battery life test were reported.
修井机在额定负荷时，不应匹配在变矩器闭锁工况。
The workover rig should not be matched under lockup conditions of the converter.
适用于重负荷或振动工况下操作的中速或低速轴承。
For medium and slow speed bearings operating under heavy load or shock-loading conditions.
对于低温的工况介质可选用低温密封系统(J单元)。
For cryogenic applications a low temperature seal system (J unit) is also available.
在实验中，大套管实验工况的火焰稳定性比小套管要好。
In this experiment, the flame stability under large bushing is better than under small bushing.
本文提出了汽车发动机曲轴多工况可靠性优化设计方法。
A fatigue reliability optimum design method for automotive engine crankshaft under various operation modes is presented.
在此基础上提出了一种新的等效干工况的计算法和图解法。
On this basis, a new calculation and graphical method of equivalent dry condition is presented.
文中给出了一个等效干工况的新的定义，并研究了它的性质。
A new definition of equivalent dry condition is given, and its characteristics are investigated.
为此，建议工况环境不理想等情况可考虑油浴式空气过滤器。
Therefore, the proposal working environment is not perfect conditions can consider oil bath type air filter.
在相应的工况点下，伺服系统能保证良好的动态性能和稳定性。
These servo systems can guarantee good performance and stability at local operating points.
运用有限元法对不同工况下平面薄膜反射镜的变形进行了计算。
By using finite element method, the deformations of flat membrane mirror have been calculated.
注：可根据用户实际工况条件设计，提供各种型号的天然气压缩机。
Note: All models of natural gas compressor can be designed and manufactured as customers' actual conditions.
负载控制加载器，模拟实际工况。也能通过变频器控制电机输出转速。
Loader was controlled with loading, and actual working state was simulated, the motor rev was controlled through transducer.
旋转式压缩机最适用于接近压缩机满负荷工况下运行的压缩空气系统。
Rotary compressor is most suitable for close to full load operation conditions of the compressor compressed air system.
该文研究了面向节点，随运行工况变动跟踪估计电网等值参数的方法。
A tracking estimation method of network equivalent parameters of facing nodes is researched with the variation of operation point.
基于汽车理论，计算出车辆道路行驶循环对应的发动机运行工况点散点。
Based on vehicle theory, the scattered operation points of engine corresponding to vehicle driving cycle are calculated.
这些现象严重危害管道的工况，并且是影响阀道局部水头损失的主要因素。
These phenomenon jeopardize the condition of the project seriously, and it is the main factor that influences the loss of local water head.
研究了工况法汽车排放测试中测功器加载扭矩的设定及其工程实现的方法。
The engineering setting methods of the torque loaded by dynamometer on vehicle exhaust test under driving mode condition are researched.
因此化油器有一些装置可以根据发动机的不同工况对化油器的工作进行调节。
Therefore, the carburetor must have many systems to alter its functions to the various operating conditions of the engine.
通过对多工况下正交异性板测试结果进行分析，说明桥面板的实际应力情况。
Through the analysis of testing results of orthotropic steel deck under more loading cases, actual stress in deck is presented.
在目前，一般采用等速燃油经济性和多工况燃油经济性评价汽车燃油经济性。
At present, we generally use isokinetic fuel economy and the status of multi-fuel economy to evaluate automobile fuel economy.
通过大量计算，对应于几种主要的载荷工况，得到了车桥横梁的应力分布规律。
Through a large amount of calculation, the stress distribution Pattern of beam axle is obtained for some main load cases.
对这些简化点的油耗进行实测(或模拟计算)，预测车辆道路行驶工况下的燃油经济性。
Then the fuel consumption at these simplified points are measured or simulated, and the fuel economy of vehicle driving cycle is predicted.
对这些简化点的油耗进行实测(或模拟计算)，预测车辆道路行驶工况下的燃油经济性。
Then the fuel consumption at these simplified points are measured or simulated, and the fuel economy of vehicle driving cycle is predicted.
应用推荐