• 通过自制的冲击腐蚀磨损试验机,施加不同极化电位对高锰钢在矿浆介质中的冲击腐蚀磨损行为进行了试验研究。

    Effect of polarization potential on the corrosion-wear behavior of high manganese steel in ore slurry was investigated by a self-made impact corrosive-wear tester.

    youdao

  • 针对传统上高锰钢作为履带板材料在实际应用中的不足,研究了一种新型的铸造m - B低合金高强度耐磨钢。

    A kind of new M-B low-alloy wear resistance steel with high strength has been studied to overcome the deficiency of traditional high-manganese steel used in making grippad.

    youdao

  • 结果表明:铸造复合中锰奥氏体钢的耐磨性是高锰钢的5.41倍。

    The results show that the wear resistance of casting composite medium manganese steel is 5.41 times that of Hadfield steel.

    youdao

  • 针对传统的高锰钢作为履带板材料在实际应用中的不足,试验采用了一种新型的铸造低合金高强度耐磨钢替代。

    A kind of new low-alloy steel with strength was studied to overcome the deficiency of traditional high-manganese steel used in making creeper truck.

    youdao

  • 应用波长扫描X射线荧光光谱法对中低合金钢、电工钢、高锰钢、不锈钢中锰元素进行测定。

    Manganese elements in low alloy steel, electrician steel, high manganese steel and stainless steel were measured with sequential wavelength scanning X-ray fluorescence spectrometry.

    youdao

  • 利用EBSD取向成像技术初步分析了含锰15%的热锻态高锰钢和含锰20%的拉伸样品中的两相组织结构及取向特点。

    Two phase structures and textures of a 15%mn steel in hot forging state and a tensile-deformed 20%mn steel were analyzed by orientation mapping based on EBSD technique.

    youdao

  • 高锰钢的优良耐磨性能使其有广泛的应用范围,但在热处理过程中却难以保证所要求的显微组织,并容易引起脱碳、晶粒长大、裂纹和变形。

    High manganese steel are widely used for its excellent abrasion resistance. However it is difficult to avoid defects of decarburization, grain growth, cracking and deformation during heat treatment.

    youdao

  • 结果表明,高锰钢的平均腐蚀速率显著高于中碳铬合金钢,腐蚀过程中高锰钢有较严重的碱脆开裂现象。

    The results showed that the corrosion weight loss rate of high Mn steel was distinctly greater than that of medium carbon chromium steel.

    youdao

  • 该材料硬度和韧性均较高,抗磨性能好,成本低,是中、低冲击条件下高锰钢的理想替代材料。

    This material has the high impact toughness and hardness, the better capability of wearresistance and the lower cost.

    youdao

  • 结果表明,在中、低冲击磨料磨损条件下,试验钢的耐磨性优于中碳低合金耐磨钢和高锰钢。

    Under lower and medium impact energy, the abrasive wear resistant performance of the steel metioned is higher than that of low alloyed medium carbon wear resistant steel and high manganese cast steel.

    youdao

  • 介稳奥氏体锰钢具有高耐磨性的原因是其在磨损过程中磨面诱发产生大量的马氏体提高了其抗磨粒的切削和剥离能力。

    The high wear resistance of the metastable austenitic Mn-steels lies in the high work hardening caused by induced martensite transformation.

    youdao

  • 中锰耐磨铸钢属脆性材料,在非强烈冲击条件下使用,是高锰钢耐磨性的2.45倍,适用于破碎中低硬度的矿石。

    Medium-magnesium cast steel is brittle and suitable for crushing low or medium hard ores Its abrasion-resistance is 2.45 as high as that of the high-magnesium steel under non-heavy impact conditions.

    youdao

  • 中锰耐磨铸钢属脆性材料,在非强烈冲击条件下使用,是高锰钢耐磨性的2.45倍,适用于破碎中低硬度的矿石。

    Medium-magnesium cast steel is brittle and suitable for crushing low or medium hard ores Its abrasion-resistance is 2.45 as high as that of the high-magnesium steel under non-heavy impact conditions.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定