利用多晶材料织构取向分布函数（ODF）对单晶性质进行加权平均可有效预估其宏观磁性各向异性。
The magnetic anisotropy of polycrystalline materials can be predicted by averaging the properties of monocrystals weighted by using orientation distribution function (ODF).
再结晶织构的强度趋于一致。
变形织构主要源自变形前的初始织构。
The deformation texture came mainly from initial texture before compression.
药芯罩材料的织构对其穿透深度具有很大影响。
Texture of metal cone materials produces a great impact for the depth ofpenetration.
在液晶态可以观察到近晶相和向列相的典型织构。
The typical smectic phase and nematic phase texture can be observed.
在液晶态可以观察到向列相的丝状织构和纹影织构。
The threaded texture and schlieren texture of nematic phase can be observed.
研究了不同的甲烷浓度对金刚石织构变化趋势的影响。
The tendency of diamond texture change was studied on the condition of various methane concentration.
XRD数据显示ECAP加工增加了织构并使衍射峰变宽。
XRD data indicate that this ECAP processing causes the XRD peaks to broaden.
考察了脉冲峰值电流密度对纳米晶镍镀层织构和硬度的影响。
The effects of pulse peak current density on the texture and hardness of electrodeposited Ni were investigated.
结果表明：热轧及常化退火工艺对硅钢冷轧织构有显著的影响。
The results show that hot rolling and normalizing annealing processes have significant influence on the cold_rolled texture of silicon steel.
介绍了采用电子背散射衍射测定深冲用再结晶铌板织构的结果。
Textures in deep punching niobium sheets have been examined by the EBSD technology in the present paper.
李一鸣；任慧平；金自力低碳钢板冷轧退火组织和织构的研究。
Ray R K; Jonas J J; Hook R K Cold rolling and annealing textures in low carbon and extra low carbon steels.
主要研究基带厚度对其立方织构、晶界角分布以及晶粒尺寸的影响。
The influence of the substrate thickness on cube texture, misorientation Angle and average grain size was studied.
实验表明：在退火条件下，再结晶织构对腐蚀铝箔的电容量有重要影响。
The experimental results showed that in the annealing condition the recrystallization texture has an important influence on the capacitance of etched al foil.
本文系统地阐述了异步轧制剪切变形条件下板材冷轧织构的模拟计算理论；
The theory of calculating deformation texture on condition of cross shear rolling was introduced.
对由取向硅钢薄带的磁感和织构实测数据计算其单晶磁感系数进行了探讨。
The calculation of single crystal magnetic induction coefficients from measured texture and magnetic induction data in a grain-oriented silicon steel strip has been discussed.
这些再结晶织构与冷轧织构之间存在与某些重合点阵关系相近的位向关系。
Orientation relationships between the annealing textures and the rolling textures were found to be close to some coincidence lattice relationships.
然后用高斯分布函数作为取向分布函数模拟了弹性常数随织构的变化情况。
Then, Gaussian distribution function was adopted as orientation distribution function to simulate the variety of the elastic constants with the texture.
本文介绍显微组织，合金成分，热处理和织构等对钛合金断裂韧性的影响。
The influence of microstructure, chemical composition, heat treatment and texture in titanium alloys has been reviewed in this article.
研究了挤压比、挤压温度及电场退火对AZ31镁合金组织和织构的影响。
The effect of extrusion ratio, temperature and electric field annealing on microstructure and texture of AZ31 magnesium alloy were investigated.
在受到切应力作用后，液晶溶液形成条带织构，条带的方向与应力方向垂直。
The band-like texture is formed in the liquid crystalline solution after shearing and the band direction is perpendicular to the shearing direction.
并用示差扫描量热分析和偏光显微镜进行表征，确定其相变温度和液晶织构。
Its liquid crystalline phases were studied using differential scanning calorimeter (DSC) and a polarizing microscope with a hot stage.
低分辨织构分析指用有限的织构函数值或少量的织构系数进行织构分析的方法。
Using limited values of the texture function or a few of its coefficients to carry out texture analysis is the so called low resolution texture analysis.
共混物的织构形态除与织构调节剂、组分比有关外，还与尼龙的结构有很大关系。
Results show that the morphology relates to not only texture regulator and composition of the blends, but also to the structure of polyamide.
采用熔融织构生长（MTG）工艺结合籽晶技术制备出大尺寸YBCO超导块材。
The fabrication of large, bulk high temperature superconducting YBCO samples was accomplished by MTG process using a seeding technique.
由于在分子中引入了手性中心和侧向氟原子，使得液晶呈现出不同寻常的近晶相织构。
The introduction of chiral center and lateral fluorines enable the liquid crystals to give unusual smectic textures.
对连续退火或罩式退火后的深冲钢板和超深冲钢板的组织以及织构进行了观测和分析。
The structure and texture of continuous or batch annealing deep drawing and extra-deep drawing steel sheets were observed and analyzed.
对薄膜中晶粒生长(正常晶粒生长和异常晶粒生长)和织构变化进行了简单的理论分析。
A simple theory analysis is presented for grain growth (normal grain growth and abnormal grain growth) and the texture change of thin films.
射线衍射分析：材料结构的微观分析，如物相定性、定量分析，应力测试，织构分析等。
X-ray diffraction analysis: analyzing the microstructure of materials, such as phase qualitative, quantitative analysis, stress testing and structural analysis.
射线衍射分析：材料结构的微观分析，如物相定性、定量分析，应力测试，织构分析等。
X-ray diffraction analysis: analyzing the microstructure of materials, such as phase qualitative, quantitative analysis, stress testing and structural analysis.
应用推荐