方法:测定材料的硬度、压缩强度、径向拉伸强度。
Methods: The surface hardness, compress strength, diametral tensile strength of composites were measured.
单颗粒压缩强度是衡量人造金刚石机械强度的重要参数之一。
The mechanical strength of diamond crystal particle is usualy eveluated by measuring its compressive strength.
介绍细粒酒精模型冰的单轴压缩强度试验研究的方法和结果。
The methodology and results of the compressive strength of fine grain ethanol model ice with rectangular and dumbbell specimens are introduced.
在较低围压条件下,岩石的压缩强度同围压系数具有线性关系。
On condition of low confining pressures, the simulating compression strength keeps linear relation with confining pressure's coefficient.
据悉,该原料是一种复合陶瓷产品,拥有高压缩强度和耐久性。
The material is a ceramic compound with a high compressive strength and durability, according to an Army statement issued this week.
加入BGE后,材料的冲击强度提高,但是压缩强度和模量减小。
Similarly, adding BGE also conduced to the improvement of impact strength and slight decrease in compressive strength and modulus.
得到了水泥砂浆石的动态泊松比、动态杨氏模量、动态压缩强度。
The dynamical Poisson ratio, dynamical Young's modulus and dynamical compressive yield strength were obtained.
钨丝体积分数超过60%以后,压缩强度与塑性变形能力反而下降。
However, the compression strength and plastic deformation ability decreased when the volume fraction exceeded 60%.
横截面积相同,高度不同的压缩试件在X方向的压缩强度相差不大。
And with the same cross section, compress strengths in X direction of specimens with different height were almost the same.
并对其压缩强度、水溶性等进行了测试,分析了影响性能的各种因素。
Then, the compressive strength and water soluble behavior of the core-mould material were tested.
结果显示,当最大接触应力大于橡胶材料压缩强度时,极易产生初始裂纹。
The FEA results show that initial crack comes into being as the maximal Von-Mise stress exceeds the compressive strength limit of rubber.
利用粉煤灰颗粒增黏的泡沫铝与利用钙增黏的泡沫铝进行压缩强度性能检测。
Through compression strength test, compare aluminum foam which fly ash particles as viscosity increaser with Ca as viscosity increaser.
热处理后,当非晶合金中出现分离相或晶化析出相时,压缩强度将急剧下降。
The compression strength of heat treated amorphous alloy is decreased remarkably due to the occurrence of precipitated phase or crystallization phase in the amorphous alloy.
准确预测含分层损伤层合板的剩余压缩强度,对复合材料具有十分重要的意义。
Predicting residual compression strength of composite laminates with delamination is a very important research subject for Engineering composite structure designers.
试验内容包括海冰的温度、盐度、密度、晶体结构、单轴压缩强度和弯曲强度。
The test conducted includes the temperature, salty, density, crystal structure, uniaxial compressive strength and flexural strength of sea ice.
与完好的纳米管相比,含有缺陷的纳米管轴向压缩强度对于温度的影响并不敏感。
In comparison to perfect nanotubes, the compressive axial strength of defective nanotubes is not affected by temperature significantly.
目的:比较整体固化与分层固化光固化复合树脂的压缩强度、拉伸强度及弯曲强度。
AIM: To compare the compressive strength, tensile strength and flexural strength of bulkily filled and incrementally filled visible light-cured composite resin.
该体系具有高的非晶形成能力,高的非晶热稳定性和高的压缩强度及较大的塑性应变。
The system is characterized by high amorphous formation ability, high amorphous stability, high compressing strength and large plastic strain.
随着球磨时间的延长,烧结合金的硬度升高,密度、横向断裂强度和压缩强度均下降。
The hardness increased, but the density, transverse rupture strength and compressive strength decreased when prolonging the holding time.
结果表明:冰厚和冰速分别服从对数正态分布和瑞利分布,海冰压缩强度服从正态分布。
It is shown that the ice thickness and the ice velocity satisfy with Lognormal distribution and Rayleigh distribution respectively, and that the ice compression strength obeys normal distribution.
结果经过酒精和藻酸钙处理的支架吸水率显著高于对照组,改性后支架抗压缩强度增加。
Results Scaf folds treated by either ethanol or alginate calcium displayed better hydrophilic ability than those untreated in the control, and the strength of anti-compress ion was reinforced.
利用土壤粘合剂对土壤进行粘结,以改善土壤的粘结性能,达到提高土壤压缩强度的效果;
The bonding performance can be modified by use of soil binder and enhanced soil compression strength was achieved.
结合压缩应力应变关系可进一步确定弹塑性失稳点的位置,从而导出压缩强度的理论公式。
Further determination of the elastoplastic instability point is facilitated by the compressional stress strain relation, which then gives rise of the final formula of the compressive strength.
近年来,玻璃钢食品罐的内斜底填充物存在着一定弊端,或者压缩强度不够,或者重量过高。
In recent years, there are some drawbacks with the traditional filling material in sloping bottom of FRP food tank. Neither its compressive strength nor weight can reach the standard requirements.
重点研究了球磨时间和烧结温度对烧结合金的密度、硬度、横向断裂强度和压缩强度的影响。
The effects of milling time and sintering temperature on density, hardness, transverse rupture strength and compressive strength were mainly studied.
发现纳米管的压缩强度,如临界轴向内力在低温下受温度影响明显,并且和应变率的大小有关。
It was revealed that the compressive strength of nanotubes, such as the critical axial load, is related to applied strain rate and also affected by temperature especially by lower temperature.
复合材料的压缩强度随着增强体体积分数的增大而提高, 屈服应变随着体积分数的增大而减小。
With the increase of the volume fraction of SiC foam reinforcement, the compressive strength increases, but the ratio of compress decreases.
用生物力学测定仪测定其不同压缩比率下的瞬时形变恢复率、最大形变恢复率及最大极限压缩强度。
Its transient recovery rate of deformation, complete recovery time of deformation and maximal compressive strength were determined with biomechanical approach.
用生物力学测定仪测定其不同压缩比率下的瞬时形变恢复率、最大形变恢复率及最大极限压缩强度。
Its transient recovery rate of deformation, complete recovery time of deformation and maximal compressive strength were determined with biomechanical approach.
应用推荐