在压缩试验中,试样直至破裂(脆性材料)或产生屈服(非脆性材料)时所承受的最大压缩应力。
3.8压缩强度(compressive strength):在压缩试验过程中,试样所承受的最大压缩应力,以兆帕为单 位。
基于1393个网页-相关网页
... 弯曲强度 bending strength mpa 压缩强度 compression strength mpa 冲击强度 impact kj/m ...
基于972个网页-相关网页
... compression steel 受压钢筋 compression strenght 压缩强度 compression stroke 压缩冲程 ...
基于80个网页-相关网页
压缩强度(compress strength) 塑胶的压缩强度高于抗拉强度。热塑性塑胶的ABS﹐聚丙烯糸高弹性的权脂﹐受荷时先膨胀﹐再进 一步压缩时﹐成扁平状﹐不会完全破裂...
基于28个网页-相关网页
单轴压缩强度 uniaxial compression strength
无围压缩强度 unconfined compression strength ; Strength uncofined compression
纵向压缩强度试验 column crush test
垂直层向压缩强度 Vertical Compression Strength
冲击后压缩强度 imp Cted COmpfeSSIOfl Streflgth ; Compression After Impact ; compression strength after impact
岩石三轴压缩强度 triaxial compressive strength of rock
三轴压缩强度 triaxial compression strength
内在压缩强度 intrinsic compressive strength
侧向压缩强度 edgewise compressive strength
There were statistically differences between the groups in acidity and compressive strength changing at the first 6 weeks after degradation test,mass loss and intrinsic viscosity changed significantly in whole period,volume contract happened after the 2nd week (p<0.05).3.
2.不同空隙率的支架抗压缩强度、降解液酸度变化在卜 周存在显著性差异:固有粘滞系数、质量变化在整个时间内均存在显著性差异:两组样品间体积变化在3七周具有显著性差异中刃.05)。
参考来源 - 聚丙交酯—乙交酯(PLGA)共聚和物组织工程支架的实验研究The gel time was 1.7h and the flexural strength and the compression strength could reach 74.6MPa and 58.2MPa respectively.
凝胶时间为1.7h,弯曲强度可达74.6MPa,压缩强度可达58.2MPa。
参考来源 - 曼尼希改性异佛尔酮二胺环氧固化剂性能研究The yield strength, compressive strength and compression rates are 1250 MPa, 2004 MPa and 33% respectively.
其屈服强度、压缩强度和压缩率分别为1250 MPa,2004 MPa和33%。
参考来源 - AlCrFeCoNiCu系多主元合金及其复合材料的组织与性能·2,447,543篇论文数据,部分数据来源于NoteExpress
为低粘度,具有一定的压缩强度的材料。
It is the material with low viscosity and some certain compressive strength.
当液剂中添加钾或钠盐时,可使固化体的压缩强度增强;
The compressive strength was increased by the addition of Na or K salt.
单颗粒压缩强度是衡量人造金刚石机械强度的重要参数之一。
The mechanical strength of diamond crystal particle is usualy eveluated by measuring its compressive strength.
应用推荐