One typical cycle of SND was analyzed on the basis of the results.

根据试验结果，对同时硝化反硝化一个代表周期作了分析。

youdao

Typical cycle times run 60 minutes up per part via RTM. However, the cycle time of CMC is only 3-7 minutes depending on the thickness of the sheet.

传统树脂转注成型的成型时间约为60分钟一个循环。但是，CMC的成型时间依不同厚度要求只需3-7分钟。

youdao

Look carefully at Exhibit 2 and the Fabritek Chart (separate from the case and included in your course packet) describing how the worker might use the four machines during a typical "cycle."

仔细看图表2和Fabritek表格(从案例中分离出并包含在你的课程包中)，它们描述了在典型“循环”中工人如何运用四种机器。

youdao

Look carefully at Exhibit 2 and the Fabritek Chart (separate from the case and included in your course packet) describing how the worker might use the four machines during a typical "cycle."

仔细看图表2和Fabritek表格(从案例中分离出并包含在你的课程包中)，它们描述了在典型“循环”中工人如何运用四种机器。

youdao