Soldered or tinned annealed wire.
焊锡或镀锡的导线。
I superglued the switch and the soldered the contacts.
我用强力胶水粘上了开关，并焊接好了触点。
The LED should be soldered within 6 hours after opening the package.
打开包装后请在6小时内作焊接。
The lead, after being skinned, will be soldered on the cores directly.
引线自动剥皮后直接焊接在电容芯子上。
The parts should be soldered in the same order as shown in the listing.
元件应该按照下表的顺序进行焊接。
I then stuck one of my NiCu rods into the hole and soldered it into place.
当时我坚持我的一个新生儿加护中心棒到孔和焊接成的地方。
The reinforcement bars are soldered on the external sides of the columns.
吊勾焊接在立柱上或焊接在加强板上。
I endeavoured to uncap the casement, but the hook was soldered into the staple.
我试着去打开那窗子，但窗钩给焊在钩环里了。
If the soldered joints are exposed, check for visible signs of crack formation.
如果露出了焊接点，检查是否形成了裂纹。
The international standard specifies a soldered pin connector for circuit boards.
国际标准为电路板选定了焊接针连接器。
The capsule element system consists of two capsule element halves soldered together.
膜盒系统包括两个焊接在一起的膜盒半元件。
The strength of soldered joint is less than a joint which is brazed, riveted or welded.
锡焊点的连接力要小于钎焊、铆接或焊接的连接点。
Air distribution piping systems almost invariably use soft copper tubing with soldered fittings.
压缩空气的分配管道系统无例外地都是用焊接管件的铜管。
Careful inspection showed that the statue's head had been cast separately and soldered in place.
仔细检查发现雕像的头部是铸好后再焊接上去的。
If we are unable to remove the oxide coat, even it is reluctantly soldered, the bonding strength is very weak.
如果我们未能将氧化层除去，即使勉强沾上焊锡，其结合力量也是非常弱的。
In this photo, a worker heats a computer board on a steel surface to remove the computer chips soldered into it.
图中的这位工人在一块钢板表面加热一块电脑电路板以取下焊接在上面的芯片原件。
But nine days later a single electrical splice overheated because it had been badly soldered, and disaster struck.
但9天之后一个简单的电气连接因为焊接不良过热造成伤害。
A copper foil solution is used to bond the glass pieces together, and then the pieces are soldered together firmly.
铜箔解决方案可使玻璃碎片结合在一起，然后一起焊接牢固。
Replacement of diodes that are soldered to the heat sink is permitted provided that a controlled heat source is used.
如果使用了可以控制的热源，可以更换焊到散热片散热板上的二极管。
I resolved to silence it, if possible; I endeavoured to unhasp the casement, but the hook was soldered into the staple.
我决定把这声音止住，如果可能的话。我试着去打开那窗子，但窗钩给焊在钩环里了。
The capacitors shall not be effected by any radiated heat from the soldered PC board or other components after soldering.
焊接后的电容器不应受到任何已焊接p C板或其他元器件热辐射的影响。
The extending portion is electrically connected by being reflow soldered to a land at a reverse surface of the substrate.
所述延伸部通过回流焊接与在基板背面的接合部电连接。
Solder end valves are designed to be soft soldered into lines without disassembly, using a low temperature solder (400of) (204oc).
焊接端口阀门适用于不需要拆卸的软焊接管线，采用低温焊料(204oc)。
For a splice, start by removing a sufficient amount of insulation and sliding a piece of shrink wrap onto the wires to be soldered.
对于一个绞接处接头，从移开足够的绝缘开始，再滑移一件热收缩管装到需焊接的线束上。
The individual parts then are soldered together, and the jeweler may mount a diamond or other gem or may engrave a design into the metal.
每个配件被组合起来，并镶嵌上钻石或者其他珠宝，也可以在金属饰品上雕刻一些文字图案。
This study benchmarked the strength of solder joints formed through the Through - Hole Reflow process against the traditional wave soldered joint.
以波峰焊工艺焊点强度为标准，研究在不同钎料量下通孔再流焊焊点的强度。
Franklin's expedition carried nearly 8 000 lead-soldered tins containing meat, soup, vegetables and pemmican - a pressed cake of shredded dry meat.
富兰克林探险队则带有近八千个装有肉、汤、蔬菜，以及压缩肉糜饼(一种用干肉捣碎压制而成的饼)的含铅焊锡封口的罐头。
Franklin's expedition carried nearly 8 000 lead-soldered tins containing meat, soup, vegetables and pemmican - a pressed cake of shredded dry meat.
富兰克林探险队则带有近八千个装有肉、汤、蔬菜，以及压缩肉糜饼(一种用干肉捣碎压制而成的饼)的含铅焊锡封口的罐头。
应用推荐