But at the Johns Hopkins University Hospital in Baltimore, about ten patients a week are being screened as part of a trial to see if actively looking for cysts can cut the death toll.
巴尔的摩约翰霍普金斯大学医院，每周约有十位患者被测试囊肿检查观察是否减少死亡人数。
A clinical trial that involves 1,000 targeted candidates rather than 20,000 from the general population can increase success rates and cut development time.
针对1000个甄选过的对象进行试验，要比20000个随机对象成功率更高，也更节省开发时间。
The trial has forced Mr Anwar to cut short his campaigning.
审讯使安华不得不减少他的竞选活动。
The trial may be gripping the Parisian elite, with newspapers filled daily with cut-out guides to understanding the drama and its cast of characters.
案子会引起巴黎社会精英的关注——从各种报纸上充斥着的千篇一律的报道去了解这场闹剧及其人物。
This paper gives a brief description and analysis of two general methods of selectingcorrection factors, those are, by cut and trial and by differential approximation.
本文简要地介绍与分析了变位系数的一般选取方法即试算法与微分逼近法。
Numerical simulation for casting process may optimize craft design, shorting trial cycle, cut the cost, decrease casting defect and assure the casting quality.
铸造过程的数值模拟可以优化工艺设计，缩短产品试制周期，降低成本，减少铸件缺陷，确保铸件质量。
The traditional cut and trial method of accuracy allocation for instruments and their problems are briefly described.
本文概述了仪器传统的精度试算法及其存在问题。
It is found that the staged cut with duplex-square has the best blasting effect in trial shafts sinking. This experimental result is analyzed with the existing achievements of rock dynamics.
结果表明：复式正方形分层分段掏槽在试验井筒中有最佳的爆破效果，并应用现有岩石动力学的成果分析了这一试验结果的原因。
Almost all objective medical experts agree that something should be done to cut back the vast jury verdicts won by clever trial lawyers in medical-malpractice cases.
几乎所有的法医学鉴定专家都同意，必须采取一些措施来减少给予在医疗事故案件中获胜一方辩护律师的出庭费用。
The application of re can not merely improve the accuracy of design and manufacture, but also shorten the trial period and cut down cost.
逆向工程的应用不但提高了产品设计和制造的精度，而且缩短了产品的试制周期，降低了生产成本。
The application of re can not merely improve the accuracy of design and manufacture, but also shorten the trial period and cut down cost.
逆向工程的应用不但提高了产品设计和制造的精度，而且缩短了产品的试制周期，降低了生产成本。
应用推荐