清单2显示了主程序循环的开头。
客户机发起调用(从主程序)。
清单8显示了主程序逻辑。
主程序逻辑首先关闭了缓冲输出。
编译主程序并同dl库相链接。
清单9展示了主程序循环的开始部分。
首先，我们分析主程序的代码。
大多数语言允许主程序使用任意名称。
连接点就是主程序和方面相遇的地方。
A join point is where the main program and the aspects meet.
文章给出了控制系统的焊接主程序。
And the main welding software for controlling system is given.
最后，我们归还二个数值给主程序。
它非常小巧，只需一个主程序即可。
给出了主程序框图和看门狗子程序。
Finally, the structure drawing of main program and the watchdog program were put forward.
任何预览或用户交互都必须来自主程序。
Any previews or user interactions have to be drawn apart from the main application.
向主程序注册序号、中断属性和线程属性。
Register the sequence number, interrupt nature, and thread attributes to the main program.
文中给出了电路原理图和主程序流程图。
Its electrical arrangement and main - program flow diagram is also given here.
设置了子程序后，我们将快速转入简短的主程序逻辑。
With our subroutines set up, we move quickly into the short main program logic.
并介绍了软件主程序和主要的中断程序。
This paper describes the software main program circle and the major interrupt program.
在主程序，声明变量。
系统软件包括主程序、子程序、显示程序。
The system software consists of main program, subprogram and display program modules.
软件设计分为两块，主程序和中断子程序。
Software design is divided into two parts, the main program and interrupt service routine.
的帮助程序遮盖了主程序，做不到这一点。
A separate help program that obscures the main program cannot do this.
在您完成主程序的定义之后，该错误将会消失。
This error will disappear after the main program has been defined.
介绍了控制方案和程序流程图及部分主程序。
Control plan, procedure flowchart and part of main procedure are introduced.
主程序完成对系统的总体调度和功能的管理。
The main program managed the general system dispatching and the function.
这会将pbawinmain类关联为主程序。
This will associate the PBAWinMain class as the Main Program.
系统软件主要由主程序和中断服务程序组成。
The system software includes the main program and interrupt service program.
您可以在按下除导航键外的任何键回到主程序界面。
You can go to the main menu by pressing any key, except the joystick.
现在，我们已经完成主程序的定义，如图13 所示。
We have completed the definition of the Main Program, as shown in Figure 13.
现在，我们已经完成主程序的定义，如图13 所示。
We have completed the definition of the Main Program, as shown in Figure 13.
应用推荐