In that it is flat with little or no shear lips.
在这种情况下，它是平的带有较小的或者没有剪切边。
Shear Angle research is one of the basic problems in metal cutting theory.
剪切角的研究是金属切削理论中的一个基本问题。
In the design of these Bridges, the designer must consider the effect of shear lag.
在这些桥梁的设计中，设计人员必须考虑剪力滞效应的影响。
In this paper, the definition and distinguish of short piers shear wall are given.
给出了短肢剪力墙的定义及判别方法。
剪剪风，情思绕。
Tie beam is an important element in frame-shear wall structure.
连梁在框架-剪力墙结构中，也是很重要的一个构件。
The results show that there is a near uniform stress state in the shear zone.
结果表明，双剪切试样受剪区域的应力状态基本为均匀分布且随蠕变时间变化很小。
The frame shear-wall system is adopted in design.
工程结构采用了框架-剪力墙体系。
A simple and visual method is used tO give shear stress distribution in symmetrical section.
文中利用一个简单直观的方法，解出了对称截面情况下的剪应力分布。
A fluid in which the shear rate is directly proportional to the shear stress.
剪切速率正比于剪切应力的流体。
Now the achievements of study in bending theory keep ahead of shear theory.
目前碳纤维抗弯加固理论的研究已远远领先于碳纤维抗剪加固。
Shear capacity and failure mechanism of steel-high strength concrete joint were analyzed in this paper.
分析了型钢高强混凝土结点的受剪承载力及破坏机理。
Shear Angle increases with the increase in cutting speed.
切削过程中，剪切角随切削速度的增加而增大。
Shear sleeve adapter allows ball to be run in place or dropped from surface;
采用剪切球座配合接头，能够确保投球从地面投放或送入到位；
Under the normal water load, nearly all cracks are in the pressure- shear condition;
正常荷载下，裂缝基本全部处于压剪状态，不存在或存在很小的拉应力；
Under the normal water load, nearly all cracks are in the pressure- shear condition;
正常荷载下，裂缝基本全部处于压剪状态，不存在或存在很小的拉应力；
应用推荐