One of the mountain's glaciers, the Furtwangler glacier, had lost half its thickness between 2000 and 2009.
富特文格勒（Furtwangler）冰川（乞力马扎罗山的一处冰川）的厚度在2000年到2009年间变薄了一半。
During the first year and a half of the study, the trauma subjects also acquired a thicker dorsolateral prefrontal cortex than controls did. After that, though, the thickness gradually normalized.
在研究前期的一年半中，受伤实验主体相比于对照组，其脑额叶前部皮层背外侧更厚，之后，厚度逐渐恢复正常。
The finished product, Corning says, is two times stronger than traditional glass at half the thickness.
Corning公司表示，最终的产品在厚度减半的情况下其硬度是传统玻璃的两倍。
It makes up more than half the thickness of the cortex.
它们组成了超过一半厚度的皮质。
Newton's half ring is rayed by laser to demonstrate the equivalent thickness interference phenomenon of film step and measure film thickness.
用激光照射牛顿半环来演示薄膜台阶的等厚干涉现象和测定薄膜厚度。
The grain size grade is about 4-5 class, and that during the thickness the central is less half a class than the lateral.
薄板坯的晶粒度的大致范围在4～5级，其中在厚度方向上薄板坯中心部位晶粒度比侧部小半个等级。
Each one was grooved to half the thickness of a pencil lead. Two slats were glued together with the lead between.
每一根木条中开了一条只有铅笔直径一半宽的槽，两个木条用胶粘合在一起，铅笔芯置于两个木条中间。
Seal welds shall be welded with half the thickness of the carrying fillet weld.
密封焊道应焊成现填角焊缝厚度的一半。
This resulted in 30 cm thick walls and roofs half a meter in thickness.
因此，该建筑的墙壁有30厘米厚，屋顶也有几乎半米的厚度。
The main living space is half a level up from the dining-hall, with a new window pushed in to the thickness of the wall, acting as a viewing point for the valley below.
主起居空间比餐厅高半层，在薄墙上有一个新的窗口，作为欣赏下面山谷的一个观察点。
The half width of transmission peak is steppedly reduced and the Q-factor on the confined state is steppedly increased with the increasing of the dielectric thickness in well.
阱区介质厚度与束缚态半峰宽呈阶梯形状降低，而阱区介质厚度与束缚态品质因子呈阶梯形状升高。
The results show that half-apex angle has a great effect on sheet thickness distribution, the smaller the half-apex angle is, the bigger the sheet thickness thins;
结果表明，半顶角对制件厚度变化起主导作用，其值越小，厚度减薄越严重；
The results show that half-apex angle has a great effect on sheet thickness distribution, the smaller the half-apex angle is, the bigger the sheet thickness thins;
结果表明，半顶角对制件厚度变化起主导作用，其值越小，厚度减薄越严重；
应用推荐