From the perspective of functional analysis, the prediction of the aeroengine exhaust gas temperature could be seen as a functional approximation problem in nature.
从泛函分析的角度出发,将航空发动机排气温度预测问题转换为一种泛函逼近问题。
The reduction of the engine exhaust gas temperature is one of the key points of this technology, which will influence the safe operation of the entire filter system.
在这一技术中,发动机的排气降温是关键环节之一,它直接影响到整个尾气微粒过滤系统的工作安全性。
The results illustrate that primary air ratio has a major effect on pulverized coal ignition and minor effects on gas temperature, oxygen concentration and unburned carbon at furnace exit.
结果表明:一次风率对煤粉气流的着火影响较大,而对出口处烟气温度、氧量以及飞灰含碳量影响较小。
The gas temperature is estimated with 2000k.
估计的气体放电温度为2000 K左右。
Inlet gas temperature has little impact on desulphurization.
烟气温度对脱硫率影响不大。
This paper presents the self - made transient gas temperature transducer.
本文介绍了作者研制的瞬态气体温度传感器。
The exhaust gas temperature is an index for the economy estimation of a thermal power plant.
排烟温度是衡量热源厂热经济性的一个指标。
Operation of the catalyst device is controlled based upon the predicted exhaust gas temperature profile.
基于预测废气温度分布控制催化剂装置的运行。
Reasons and harm of higher gas temperature at the final cooling stage are analyzed and solutions are proposed.
分析了终冷段煤气温度偏高的危害及原因,并提出了处理办法。
With the increase of the flue gas temperature, the efficiency of desulphurization showed a decreased tendency.
随烟气温度的升高,脱硫效率表现出减少的趋势。
Measurements were also conducted for the time-averaged gas temperature and species concentrations in the combustor.
同时还测量了该燃烧室内气体平均温度和组分浓度分布。
The magnitude of the turbulence then follows directly from the observed line with if the nebular gas temperature is known.
如果已知星云气体的温度,则湍流的大小可直接从观测的谱线宽度得出。
Deviation of flue gas temperature at furnace exit may bring about harm to the safety and economic operation of the boiler.
锅炉炉膛出口烟温偏差给安全经济运行带来危害。
These methods have already been used for the gas temperature measurement at the exit of the high temperature rise combustor.
分析和比较了两种计算方法,这些方法已应用到燃烧室出口高温燃气温度测量中。
The result shows that gas temperature near the stave is the main factor that affects heat transfer and slag skull thickness.
结果表明,复合冷却壁附近炉气温度是影响其传热行为和渣皮厚度的主要因素。
For the droplet considered, the life time of droplet reveals the index declining rule along the flue gas temperature varying.
对于文中研究的液滴,无量纲完全蒸发时间随烟气温度变化呈指数递减规律。
It deduced the way to do the temperature corrections in calculating calibration pressure when considering the gas temperature change.
考虑到气体温度变化,给出了对校准压力进行温度修正的方法。
After scaling the boiler flue gas temperature will increase, reducing the efficiency of the boiler heating, coal consumption increased.
锅炉结垢后将使排烟温度增高、锅炉供暖效率降低,耗煤量增加。
The distributions of gas temperature, O2, CO2, CO, and NO concentrations were measured under different swirl numbers for the primary air.
测量了在不同的一次风旋流数下,气体的时均温度、O2、CO2、CO和NO浓度的分布。
The flue gas temperature of direct-fired machine is too high to save energy. A recovery device of residual heat is installed in the flue.
直燃机排烟温度过高,不利于节能,在烟道上加设余热回收装置。
With some practical examples, this paper presents a general method to determine the extreme value of ideal gas temperature in arbitrarily process.
文章给出了求解理想气体任意过程温度最值的一种普遍方法,并且举例加以说明。
As an example, the method has been used to reconstruct the hot gas temperature fields, and the results are compared with thermocouple measurements.
作为一个应用实例,测试了某截面上的气体温度分布,并与热电偶测量的值进行了比较。
Flue gas temperature fuzzy control dimly deduces turndown ratio of mixer valve according to temperature values of multipoints and their variations.
烟气温度模糊控制根据系统多点温度值及其变化模糊推断混风阀的开度。
On the premise of security operation, to decrease the exhaust gas temperature and to control surplus air are both effective measures of energy-saving.
因此在考虑加热炉安全运行的前提下,降低排烟温度以及控制过剩空气系数是比较有效的节能措施。
Use several kinds of thermal calculation methods of boiler's furnace, and calculate the outlet flue gas temperature of a low load of some supercharged boiler.
运用几种热力计算方法,对某型船用增压锅炉低负荷工况的炉膛出口烟气温度进行了计算。
Electric Contact Bimetal thermometer is a site for low-temperature measurement instrumentation, can be used to directly measure the liquid, the gas temperature.
电接点双金属温度计是一种适合测量中低温的现场检测仪表,可用来直接测量液体、气体的温度。
Electric Contact Bimetal thermometer is a site for low-temperature measurement instrumentation, can be used to directly measure the liquid, the gas temperature.
电接点双金属温度计是一种适合测量中低温的现场检测仪表,可用来直接测量液体、气体的温度。
应用推荐