Light-line is one of the companies that will most benefit if new long-distance fiber-optic telecommunications networks are constructed.
如果建设新的长途光纤通信网络，Light-line将是最大的受益公司之一。
The dark pulses also transmit through certain fiber optic cables faster and with less noise than light pulses.
暗脉冲还通过光纤传输的速度比光脉冲速度更快而且噪音也更低。
Dark pulses don't have the same drawbacks, which should improve the transmission and detection of light through fiber optic cables.
黑暗脉冲没有可见光通过光纤时那样的缺陷，它能够提高的光线在光纤电缆里的传输并对它进行检测。
Fiber optic cables and lasers capable of sending pulses of light down them already existed when Dr. Kao started working on fiber optics.
当高锟开始研究光纤学的时候激光能够发射光脉冲通过光纤和已经存在。
When beams of light pass through a fiber optic cable, they tend to degrade.
当光束通过光纤，光强度趋于降低。
The sensitivity of intrinsic fiber optic Fabry Perot (F P) magnetic sensor is studied and the influence of linewidth of light source is discussed.
分析了内置式光纤法布里珀罗磁场传感器的灵敏度及光源线宽对灵敏度的影响。
Birefringent a fiber optic term. Having a refractive index that differs for light of different polarizations.
一种光纤术语。折射率与不同极化的光折射率不同。
The paper reports a novel low loss single mode fiber optic coupler and describes the design procedures employing light matrix method and gradient optics theory.
本文报导了一种新型低损耗单模光纤的光学耦合器。叙述了应用光线矩阵法和梯度光学理论的设计方法。
The Tritium illuminates the aiming point in total darkness, and the fiber-optic self-adjusts reticle brightness during daylight according to ambient light conditions.
三重氢照明被用在完全黑暗状态，而视觉纤维（自动调节）用在白天或者可以说在有外界光线的情况下。
In intensity-modulated type optic fiber sensors, luminous intensity of a light source and operating stability of photoelectric receiver are the key factors for determining measuring accuracy.
在强度调制型光纤传感器中，光源发光强度和光电接收器工作的稳定性，是决定测量精度的关键因素。
A way to the the sensitivity of reflected light power collected by reflective type fiber-optic displacement sensor is given.
给出了反射式光纤位移传感器反射接收光强灵敏度的计算方法。
In this thesis, kinds of novel fiber-optic chemo - and bio - sensors based on mode-filtered light detection (MFLD) were presented, originating from the proposition of MFLD mechanism.
本论文从基于光纤模式滤光检测的机理入手，致力于研究一类新型的基于模式滤光检测的光纤化学与生物传感器。
The spectrum transmission function (STF) of optic fiber ring is obtained with the theory of partially coherent light.
根据部分相干光理论，得到了光纤环光谱传递函数。
A novel reflective fiber optic microphone was introduced. It USES a reflective fiber optic sensing probe to realize the outside modulation of sound to light.
一种新型的反射式光纤麦克风，它利用反射式光纤传感探头实现声音对光的外调制。
The errors caused by light source, optical fiber, electro optic crystal and opto electric detector in optical fiber voltage transducer are presented.
研究了光纤电压传感器光路系统中光源、光纤、电光晶体和光电探测器对测量误差的影响。
The part of optic paths includes optical fiber strain sensor, lamp-house, optical fiber coupling instrument and light dispersion equipment.
光路部分包括光纤传感器、光纤、光源、光纤耦合器以及设计的解调光路部分。
The light center of gravity method is applied to processing optic fiber exited spot signal for acquiring the position features of optic fiber ends.
采用“光重心法”对光纤出射光斑信号进行处理，获取光纤端部的位置特征。
The above system chiefly consists of light source, optic fiber sensor, photo detector and signal processing circuit.
应变测量系统主要由光源、传感光纤、光电探测器和信号处理电路组成。
The intensity modulation method is the oldest and simplest method for fiber-optic sensor, in which a homochromatic laser is used as system light source.
强度法是干涉型传感器采用的最古老、最简单的方法，它采用单色激光光源作为系统的光源。
The light center of gravity method is applied to processing optic fiber exited spot signal.
采用“光重心法”对光斑信号进行处理。
Using the minisize CCD detector, LED light source and a fiber optic, a fiber optic oxygen sensor based on fluorescence quenching has been developed.
将该氧传感膜与传光光纤相耦合，搭配商品化的LED光源和微型CCD检测器，研制了一种基于荧光猝灭原理的光纤氧传感器。
The spark optic fiber sensor has the advantages of high anti-interference ability, low cost, operating reliability and strong light signal is feasible to applied to combustion knocking detection.
火花塞光纤传感器抗干扰好、成本低、工作可靠、光信号强，用于爆震燃烧检测是完全可行的。
A tapered electro-optic polymer waveguide is proposed and designed for coupling light between single-mode optical fiber and polymer waveguide.
提出并设计了一种基于电光聚合物的锥形波导，可用于单模光纤与电光聚合物波导器件之间的连接。
In the CPS (Compact Prototyping System) stereolithography apparatus, the UV light is used as a light source, and the optic fiber transmits the light to the resin surface to model while scan.
光固化成型系统中，以紫外灯作为光源，通过光纤传输紫外光到液面，进行扫描成型。
The program is organized by the towers central branching atrium, enhanced by daylight channeled from above via an integrated light-transmitting fiber-optic array.
该计划以大厦中央分支中庭为主轴，集成光传输光纤阵列从上方引导的日光加强了这一设计。
Superluminescent diode(SLD)is an idea light source for fiber optic gyroscopes which can meet the requirements of the light source for high output power, low coherence and good stability.
光纤陀螺用光源要求输出功率高、相干性低、稳定性好。超辐射发光二极管（SLD）是能满足这些要求的理想光源。
With light propagating in the optic fiber, energy will decline gradually and the remote signal will disappear. Thus, signal should be enlarged and the ability of light - coupling will be improved.
光在光纤中传输，能量会逐渐衰退，造成远距离信号的消失，因此就要对光在中间进行放大和提高光注入光纤的能力。
In the application of intensity modulation type fiber optic sensor, the power fluctuation of a light source is a key factor affecting sensor accuracy.
在强度调制型光纤传感器的应用中，光源的功率波动是影响传感器精度的关键。
In the application of intensity modulation type fiber optic sensor, the power fluctuation of a light source is a key factor affecting sensor accuracy.
在强度调制型光纤传感器的应用中，光源的功率波动是影响传感器精度的关键。
应用推荐