It also describes the principle of thickness measure, circuit and connected circuit of major control unit.
详述了测厚原理、电路及主控单元接口电路。
To avoid this problem, the system is designed with two connected circuits: the starter circuit and the control circuit.
为了避免这个问题，启动系统设计有两套电路：启动机电路和控制电路。
Consider a simple circuit that consists of one digital input connected to a digital output.
假设，一个最简单的电路，只有一个数字输出端连接一个数字输入端。
Because you need both a voltage source and a ground in order to create a complete circuit, you need to have a sourcing input or output connected to a sinking output or input.
因为在一个完整的电路中必须有一对电源和地。
Electrostatic shielding is provided by surrounding the signal path with a conductor connected to a low impedance point in the circuit, preferably the lo input terminal of the measuring device.
利用连接到电路中一个低阻点的导体，将信号通路包裹起来，即实现了静电屏蔽，该低阻点最好是测量设备的LO输入端子。
Ideally, when a voltmeter is connected to a relatively low impedance circuit in which no voltages are present, it should read zero.
在理想的情况下，当把电压表连接到一个没有电压的、阻抗比较低的电路时，电压表的读数应当为零。
Note that before the capacitor is switched to the picoammeter, the capacitor is connected to circuit LO.
请注意，在电容器被切换至皮安计之前，它是被连接到电路lo的。
Partial Pressure Connection: the varistor of the two fixed end of the bipolar power supply, respectively connected by a sliding side and either a fixed terminal connected to the circuit.
分压接法：将变阻器的两个固定端分别与电源的两极相连，由滑动端和任一固定端连接到电路。
This circuit is connected properly, so this current doesn't flow through the electrometer measurement circuitry and, therefore, doesn't cause any measurement errors.
此电路连接恰当，该电流不流过静电计的测量电路，所以不产生任何测量误差。
The circuit lines each have one end connected to the driving chip and the other end connected to the signal lines.
该电路线每个均具有连接至驱动芯片的一端和连接至信号线的另一端。
The internal processor bus described in Sec. XX is connected to the external processor bus by a set of bus buffers located on the microprocessor integrated circuit.
XX节所描述的内部总线通过一组位于微处理器集成电路内的总线缓冲器与外部总线连接。
Placing the electrometer in the volts mode and then enabling external feedback switches the feedback circuit from an internal network to a feedback circuit connected to the preamp output.
将静电计置于电压模式，然后打开外部反馈，就把反馈电路从内部网络切换到连在前置放大器输出端的外部反馈网络上。
Scope ground may be connected to other DC level in the circuit other than ground provided the circuit under test is floating.
如果测试电路是浮动的﹐示波器的地也可以接到除地以外的其他直流电平处。
Distribution circuit breaker a distribution circuit breaker is a device used for overload and short current protection of loads connected to a main distribution device.
配电线路开关配电线路开关是给连接在主配电设备上的负荷提供过载和短路保护的装置。
For high frequency, or low amplitude measurement, probe ground shall be connected to appropriate points in the circuit under test.
对于高频或低幅值测量﹐探头的地应接到测试电路中的适当位置。
Similarly, a current transformer is connected with its primary in the high-voltage circuit.
同样，电流互感器是与它的主要的高电压电路。
As the droplets jump, they carry charge from one plate to the other; if the two plates are connected through an external circuit, that charge difference can be harnessed to provide power.
当水滴下落时，他们携带电荷从一个极板到另一个极板，如果两块极板通过外回路连接，它们之间的电荷差就能用于提供能量。
The electrical elements connected include circuit breaker disconnector and earthing switch current transformer voltage transformer lightning arrester bus etc.
连接的电气元件有断路器、隔离开关与接地开关、电流互感器、电压互感器、避雷器、母线等。
If you try this with the component connected into a circuit with a power supply, the most likely result is that the meter will be damaged.
如果你试着去测量连接到一个电源电路的元器件，绝大多数的结果是仪表将被损坏。
As a try for circuit standardization, the system realizes the standard protection circuit unit and recovering-time circuit unit, which are connected to system through standard 44 pins' bus interface.
作为标准化的尝试，本系统实现了标准的保护电路单元和恢复时间电路单元，通过44芯总线插座与标准总线接口连接。
An electrical circuit or network is composed of elements such as resistors, inductors, and capacitors connected together in some manner.
电路或者电网络是由电阻、电感和电容等元件以某种方式连接而构成。
The protection circuit should be enclosed in a light-tight shield. the shield should be connected to the low of the ammeter.
保护电路应当做遮光屏蔽，且屏蔽要接到安培计的低压端。
Figure 2-37 shows a generalized feedback circuit connected to a source impedance.
图2 -37示出连至源阻抗的一般反馈电路。
The outer part of the metal shell is fixed with a temperature display screen connected with the control circuit.
所 述金属壳体的外部固定有与控制电路相连接的温度显示屏；
The current starts flowing as soon as the battery is connected to the closed circuit.
当把电池一接到闭合电路上，电流就开始流动。
The current starts flowing as soon as the battery is connected to the closed circuit.
当把电池一接到闭合电路上，电流就开始流动。
应用推荐