The dynamic response question of composite pavement under moving load is analyzed by using the finite-element numerical calculation method.
应用有限元数值计算方法，分析了复合路面在移动荷载下的动力响应问题。
Using the finite element method software ANSYS, the stator temperature field of the hydroelectric generator is analyzed and calculated, the corresponding temperature field picture is given.
在此基础上应用有限元法的通用软件ANSYS，对大型水轮发电机定子温度场进行分析与计算，绘制了相应温度场图。
The effects of matching materials on the brake temperature of braker were investigated by using the finite element method to simulate the temperature transient process of disc brake.
采用有限元法模拟盘式制动器制动过程瞬态温度场，研究了材料匹配性对制动器温度场的影响。
The stator's characteristics of vibration and input impedance were analyzed by using the finite element software ANSYS. A new decoupling method between the two vibrators was presented.
对电机的运行机理进行了分析，并利用有限元软件ANSYS分析了电机定子的振动特性和阻抗特性，同时提出了一种振子间解耦的方法。
The magnetic distribution of the single-coil and dual-coil magnetic rheological dampers with the same effective piston length was analyzed by using the finite element ANSYS software.
采用有限元ansys软件，分析了相同活塞有效长度下的单线圈与双线圈结构磁流变阻尼器的磁场分布情况。
In this paper, the theoretical model of cross-flow of grain cleaning fan on farm is proposed by using the finite element method.
本文应用有限元方法，建立了横流式农用清选风机内部的气体流动数值模拟模型。
It was universal to study ship's longitudinal strength by using the finite element-method.
目前国内外普遍运用有限元方法研究船体的总纵强度。
According to the measured results, a reasonable boundary condition can be set up and then the field distribution can be calculated by using the finite element method.
按测量结果，确定了一个合理的边界条件，用有限元法模拟计算了沿轴场分布。
Computation and analysis of the cylinder block stress and deformation are conducted on a 6125q diesel engine in supercharged or cylinder diameter enlarged situation by using the finite element method.
本文应用有限元法，对6125Q型柴油机机体在增压和扩缸时的变形和应力进行了计算分析。
The modal and harmonic response analysis of the structure were implemented using the finite element analysis method with ANSYS software.
使用有限元分析软件ANSYS对结构建模，并进行模态和谐响应分析。
Using the finite element method to analyze the mixing chamber, the temperature distribution as well as the change situation.
利用有限元法对混炼过程中密炼室、胶料的温度分布以及变化情况进行了分析。
Symmetrical folding of a single layer and folding process of an overfold are analyzed by using the finite element method.
本文采用有限元方法，分析单层对称褶皱作用和一个天然倒转褶皱的变形过程。
The natural frequency of the gas column in simple pipelines was solved using the finite element analysis method. The result agreed with that derived with transportation matrix method.
采用有限元分析方法，对简单管道气柱的固有频率进行求解，其结果与用传递矩阵法求得的结果是一致的。
The frame of a new style motorcycle named Sport Recreation Vehicle (SRV) was researched. Using the finite element mode analysis method, the vibration mode of motorcycle frame was analyzed.
以一新型运动型多功能休闲摩托车车架为研究对象，采用有限元模态分析的方法，对车架振动模态进行了分析。
In this paper, the static analysis of Hydroplan of hydropower station engineering of Xianrendong is performed by using the finite element software of ANSYS.
本论文通过有限元分析软件ANSYS对贵州省纳雍县仙人洞水电站的厂房工程进行了结构静力分析。
Because hinges need linear deformation, using the finite element software ANSYS to study the performance of the hinges, then discusses the hinges parameters' impact on linearity.
因为铰链需要线性变形，因此利用有限元分析软件ANSYS对柔性铰链进行系统的研究，讨论铰链的各个参数对其线性性能的影响。
Furthermore, the fixture structure is optimized by using the finite element analysis software ANSYS.
并利用有限元分析软件Ansys进行辅助设计，对其结构进行优化。
The predicted transmission loss of perforated tube silencers using the finite element method and experimental results are compared and showed good agreement.
使用有限元法计算穿孔管消声器的传递损失，并与实验测量结果进行了比较，二者吻合良好。
The Maxwell stress between magnet and keeper was integral analyzed using the finite element method, and the attractive force between magnetic attachments was obtained.
通过有限元法积分作用于闭路磁体与衔铁之间的麦克斯韦应力，算得磁性附着体的固位力。
Physical insight is valuable in using the finite element method.
在利用有限方法时，物理上的观点是有价值的。
Based on cutting and vibrating theories, the dynamic behavior of micro drill is studied by using the finite element method.
基于切削和振动理论，利用有限元技术对微细钻头振动钻入动力学特性进行了深入地研究。
The sustainability of perforating casing with screw holding is analysed by using the finite element software ANSYS.
文章利用ANSYS有限元分析软件，对螺旋布孔射孔套管的承载能力进行了分析。
By using the Finite Element Method (FEM), the nonlinear thermal vibration characteristics of composite laminated plates under linear temperature field were investigated.
采用有限元方法研究复合材料层合板结构在线性温度场作用下非线性热振动特性。
The torsional stiffness of a large turbogenerator rotor body and the factors influencing the stiffness are studied systematically in by using the finite element method.
本文利用有限元数值计算方法，系统研究了发电机转子本体部分的扭转刚度及其主要的影响因素。
Stochastic dynamic responses of planar rigid-frame structures to quake loads are investigated by using the finite element approach.
本文利用有限元方法，分析了平面刚架结构对地震载荷的随机动力响应问题。
Matrix step is low by using the finite element transfer matrix method. Natural frequency by calculation approaches to actual natural frequency and the error is allowable.
用有限元传递矩阵法分析火炮身管固有振动特性，矩阵阶次低，计算所得的固有频率与实际固有频率接近，误差在允许的范围内。
The fifth chapter studied the key shaft, linking brace and pole base of experiment platform, using the finite element analyzing software, providing the intension checking and structure optimizing.
第五章，利用有限元分析软件对实验台的关键件主轴、曲柄联接柱及长杆固定座进行有限元分析，并进行了强度校核和结构优化。
The fifth chapter studied the key shaft, linking brace and pole base of experiment platform, using the finite element analyzing software, providing the intension checking and structure optimizing.
第五章，利用有限元分析软件对实验台的关键件主轴、曲柄联接柱及长杆固定座进行有限元分析，并进行了强度校核和结构优化。
应用推荐