The blanket reduces the stress that the weight of the thighs places on the S-I joint. Supporting the outer thighs is also good practice for restorative or relaxation poses.
支撑在大腿外侧的毯子，帮助承担了部分大腿重量，从而减轻骶髂关节的压力，是很好的恢复和放松法。
If weight bearing or stress loading of the affected joint continues, thinning of the cartilage may progress to eventual full-thickness cartilage loss.
如果受损的关节持续负重或承受应力，软骨变薄可进行下去，直到最后全层软骨消失。
Stress sensitivity means the influence of pressure difference produced by joint working of the matrix stress and the porous fluid pressure on the porous microstructure.
应力敏感性是指骨架应力和孔隙流体压力共同作用产生的压差对微观孔隙结构的影响。
Installed on the subgrade, especially when the basis of subgrade stress is very high, which can absorb and fundamentally weakened cracks or traffic and the tensile stress of the joint values.
安装到路基上，尤其当路基的基础应力很高的情况下，它能吸收并从根本上减弱有裂缝或交通而产生的张应力缝值。
The grids completely meet with the requirements for soldering on surface color , welds quality, overall dimension, rupture stress and joint thickness.
而定位格架的表面颜色、钎焊缝质量、外形尺寸、破断力和结合层厚度均达到钎焊技术要求。
Installed on the subgrade, especially when the basic tensile stress is very high, which can absorb and fundamentally weakened cracks or traffic and the tensile stress of the joint values.
安装到路基上，尤其当基础张应力很高的情况下，它能吸收并从根本上减弱有裂缝或交通而产生的张应力缝值。
This fracture usually results from the joint effects of axial compression, and rotating or shearing stress.
这种骨折通常是轴向压缩应力与旋转或剪式应力综合作用的结果。
The radial stress is press stress in the joint axis and is gradually from press stress chang into pull stress in the area further away from the axis.
接头内径向残余应力在轴心处为压应力，随着远离轴心逐渐由拉应力变为压应力，在接头边缘区域为拉应力。
That the thread endures high alternate stress is the first cause of failure of thread joint.
螺纹部位承受高的交变应力，是导致螺纹联接螺纹失效的主要原因。
Other risk factors are repeatedly putting stress on a joint or having an earlier injury.
其他风险因素包括关节反复受力或存在早期损伤。
Subsequently, the high stress areas and the stress distribution of the joint have been found out by handling and analyzing the large quantity data.
然后，根据试验结果得到的大量数据，经分析找出节点环板的高应力区及其大致的应力分布情况。
One method to decrease the peak stress at the joint of nozzle and thick cylinder was introduced in this article.
本文介绍了一种降低厚壁圆筒与接管连接处应力峰值的方法。
It is shown that the irregularity of the joint surface apparently affects the stress wave transmission.
研究结果表明：节理面不规则结构明显地影响应力波的传播性质。
The results show that the stress corrosion is the main failure causing of the bellows expansion joint, while the local pit corrosion, residual stress and the working stress is the necessary condition.
结果表明，应力腐蚀是该膨胀节失效的主要原因，而局部的点蚀和残余应力、工作应力是应力腐蚀的必要条件。
The monitoring project of Zhouning Hydropower station underground plant and water intake system including monitoring of the surrounding rock deformation, bolt stress, osmotic pressure and joint.
周宁水电站地下厂房及引水系统的监测项目包括围岩变形监测、锚杆应力计监测、渗透压力监测、测缝计监测。
Through extending the wear plate at the saddle and using the flexible saddle, the circumferential peak stress at the joint of the shell and the saddle can be decreased efficiently.
本文介绍通过鞍座上垫板的伸出和采用柔性鞍座，即能有效地降低鞍座边角处的环向峰值应力。
The soft joint can suit to the nonuniform settlement of foundation and decrease stress concentration at connection part.
软接头能较好适应地基不均匀沉陷，减小心墙和防渗墙结合部的应力集中。
Not only that, but the M-GLIDE is ergonomically designed for ease of motion and joint stress and helps prevent computer related injuries.
不仅如此，在M -GLIDE的人体工程学设计，便于运动和分散压力，有助于防止电脑使用中相关的损害。
Joints are crucial factors in rock masses engineering, so using stress waves to invert joint attitude is a valuable practice.
节理对岩体工程有重要的影响，采用应力波反演节理产状有重要的工程意义。
The results show that stress in hollow beam and semi-shaft bush is much less than permissible stress, while joint of suspension frame and axle housing has too large local stress.
结果表明，驱动桥壳空心梁和半轴套管部分的应力远小于材料的许用应力，而悬架支座与桥壳连接处出现了局部应力过大的情况。
The results show that the joint forms which have less stress, concentration and less peel stress can raise bonding strength greatly.
试验结果表明：降低应力集中及剥离应力小的接头形式可有效地提高胶接强度。
When the muscles are relaxed the stress is moved to the ligaments binding the joint.
当肌肉放松时，压力转移到与关节紧密相连的韧带上。
Basing on SYSWELD software, stress of in-service welding joint of X70 pipeline steel has been simulated, and residual stress of in-service was compared with routine welding.
采用SYSWELD焊接模拟软件对X70级管道在役焊接接头应力进行模拟，并将在役焊接残余应力与常规焊接进行对比。
The remarkable changes of contact stress of patellofemoral joint, the cartilaginous degeneration, and matrix proteoglycan loss not found in the lateral cartilaginous side of patella.
而髌骨外侧面软骨接触压力无明显改变，软骨变性不明显，蛋白多糖含量无明显减少。
The results show that the early failure of the corrugation expansion joint was results from the stress corrosion cracking in the components.
结果表明，波纹膨胀节发生早期失效是由于构件发生应力腐蚀开裂所致。
Longitudinal crack of drill pipe box joint is brittle fracture at low stress.
钻杆接头的各种纵向开裂属于低应力脆性断裂。
As the bolt tension increase, the tension of rail web, stress of joint bar and stress of joint bolt would increase accordingly, but the displacement of rail would become smaller.
螺栓扭矩增大，接头区钢轨轨腰拉力、夹板应力、螺杆内应力都会增大，而钢轨位移会随着螺栓扭矩的增大而减小。
Thus, the corresponding joint stress can be calculated from the strains measured.
可以根据测得的应变值，计算得出相应的连接强度。
In my personal experience, the cold joint could be due to manufacturer defect or mechanical stress that over-stress the connector's joint over time.
在我个人的经验，冷联合可能是由于制造缺陷或机械应力，过度强调连接的联合随著时间的推移。
In my personal experience, the cold joint could be due to manufacturer defect or mechanical stress that over-stress the connector's joint over time.
在我个人的经验，冷联合可能是由于制造缺陷或机械应力，过度强调连接的联合随著时间的推移。
应用推荐