Provided is a position estimation method and device using GPS signals.
本发明致力于一种使用GPS信号确定或估计位置的方法和设备。
This paper presents an improved scheme of rotor position estimation for PMSM.
介绍了一种永磁同步电动机转子位置估算的改进方法。
The rotor position estimation is obtained by the position perturbation algorithm.
提出一种采用位置扰动算法检测永磁同步电机转子位置的方法。
A novel method for the transformer tap position estimation is proposed in this paper.
本文提出一种新的变压器档位估计方法。
A position estimation scheme in visual servo system with single camera mounted on a robot is proposed.
提出了单摄像机安装在机器人上的视觉伺服系统的位置估计方法。
Finally, the stator resistance effect of rotor position estimation in high frequency voltage signal injection is investigated.
最后，探讨了旋转、脉动高频电压信号注入法下定子电阻对转子位置估算影响的问题。
The more accurate achieved NUH position estimation is used as the position feedback signal necessary for NUH vision-guided control.
将得到的更精确的NUH位置估值作为NUH视觉导引控制所需的位置反馈信号。
A novel method for speed and rotor position estimation of BLDCM, which applies extend Kalman filter (EKF), is presented in this paper.
本文提出了一种利用扩展卡尔曼滤波器算法来估计BLDCM的转速和位置的方法。
This paper presents an implementation of rotor position estimation with self sensing method for permanent magnet (PM) synchronous machines.
提出了一种永磁同步电机转子位置估算的自检测方法。
In order to avoid some control problems on mechanical sensor, a control strategy based on the position estimation for doubly-fed generators is presented.
为了避免由机械传感器所带来的一些控制上的问题，提出了一种基于位置估计的双馈风力发电机的控制方案。
Saturation effect is considered for the rotor position estimation. The mathematical model including saturation is built for compensating the effect of saturation.
考虑电机的饱和对转子位置估计的影响，建立了包含电机饱和影响的数学模型，以补偿饱和对转子磁极位置估计的影响；
The navigation subsystem of the mobile robot fuses the position estimation obtained by a vision system with the position estimated by odometry using a Kalman filter.
移动机器人的导航子系统利用卡尔曼滤波器，融合由视觉系统与由里程计获得的位置估计值。
And electric steady also is introduced to estimation of rotor position, which solves effectively the problem of big error on rotor position estimation in process of dynamic.
同时将电气稳态的概念引入转子位置估计中，有效地解决了电机在稳态情况下转子位置估计误差大的问题。
This paper reviewed the position estimation methods of various motors and analyzed their advantages and disadvantages. By using these methods, position sensors can be eliminated to a great extent.
文章综述了各种电机的一些位置估计方法，分析了其优缺点，这些方法在很大程度上可取代位置传感器。
If you're consistent with your framework and you analyze your results, you're in a good position to refine your framework and, in time, improve your estimation ability.
如果与框架保持一致，分析结果之后您就可以对框架进行优化，从而及时地提高评估能力。
Last, MATLAB6.1 as simulation tool is used to make research for the whole SRD system and operating characteristics and rotor position Angle estimation.
最后采用MATLAB6.1软件作为仿真工具，对SRD系统以及SR电机的控制特性和转子位置估算方法进行了仿真研究。
Chapter III studies tactical parameters estimation of boost phase and impact position prediction problems based on prior trajectory profile.
第三章研究了基于先验弹道模板的主动段战术参数估计与落点预报问题。
Estimation of Doppler central frequency has an important effect to accuracy of fixed position in the fixing approach with no reference points for ocean SAR.
在无参考点海洋sar定位方法中，多普勒中心频率估计对定位精度有着重要的影响。
In this paper, a transformer tap position tracing estimation algorithm based on turn ratio changing detection is proposed.
本文提出一种基于变比变化检测的变压器抽头位置跟踪估计算法。
This paper examines how to use AR Spectrum estimation method to improve the locating precision of the material 's flaw position in ultrasonic testing.
文中详细介绍了如何采用AR谱估计方法来提高超声无损探伤中对缺陷位置的精确定位。
The proposed algorithm can realize exact estimation of the rotor position with certain robustness and reliability and can directly replace the sensor of position.
该方法可以实现转子位置的精确估计并具有一定鲁棒性和可靠性，可取代直接的位置传感器。
The state equation and detecting equation of the position error of moving target are built, the location and track to moving target is achieved by least-square estimation and Kalman filter algorithm.
列出了对位置偏差估计的状态方程和测量方程，用加权的最小二乘估计和卡尔曼滤波算法，实现了定位和跟踪。
The conditions for the existence of periodical solutions, and the estimation of the perimeter and relative position of the limit cycles are obtained.
证明了周期解的存在条件，并估计了有关极限环的周长和相对位置。
Simulation results show that it provides quite well improvement of location accuracy than linear line of position algorithm and Taylor series location estimation algorithm.
仿真结果表明这种新方法比线性位置线算法和泰勒级数展开最小二乘位置估计算法性能优越，在一定程度上提高了无线定位的准确度。
The target position information was acquired by the SVM estimation output and the weight vector.
获得目标位置信息的支持向量机估计输出和权重向量。
A filter design for rendezvous and docking with non-cooperative target was also given which can provide estimation information of relative position, velocity, attitude Angle and angular rate.
设计了针对空间非合作目标对接段的滤波器，能够提供对接段相对位置、速度、姿态角及角速率估计信息。
This paper has summarized the basic theory for GIS spatial position data uncertainty estimation and the error propagation, and practical estimation methods.
本论文归纳总结了GIS空间位置数据不确定度估计和误差传播的基础理论和实用的估计方法。
Based on the saturation effect of winding inductance, an estimation method of initial position for SPMLSM without a position sensor was presented.
利用绕组电感饱和效应，即由于磁路饱和引起的电感随动子位置角变化的规律，检测表面式永磁直线同步电机动子的初始位置。
A parameter estimation algorithm of chirp signal which makes use of the position and magnitude of non zero cyclic spectral peaks to estimate the three parameters is presented.
本文提出了利用非零循环频率处谱峰的位置与大小估计这三个参数的算法，该算法不需要信号参数的先验信息；
A parameter estimation algorithm of chirp signal which makes use of the position and magnitude of non zero cyclic spectral peaks to estimate the three parameters is presented.
本文提出了利用非零循环频率处谱峰的位置与大小估计这三个参数的算法，该算法不需要信号参数的先验信息；
应用推荐