This means that you can redirect output to a remote command.
这意味着您可以将输出重新定向到远程命令。
This command produces the output shown in Listing 4.
这个命令生成的输出如清单4所示。
This command produces the output shown in Listing 5.
这个命令生成的输出如清单5所示。
The output of the command should tell you the host name assigned to this IP address.
这个命令的输出应该告诉您分配给这个IP 地址的主机名。
You can pipe output from one command to another using pipes, |.
您可以用|管道将来自一个命令的输出送到另一个命令。
The greater than sign (> allows you to redirect output from the command.
大于符号 >允许您对该命令的输出进行重定向。
Listing 2 shows the output of this command.
清单2列出了这个命令的输出。
You may be wondering what happens to any output from the command.
您可能想知道对来自命令的输出会如何处理。
A fourth screen, command status, displays the command, output, and status of the command.
第四个屏幕是命令状态屏幕，它显示命令、命令的输出和状态。
The output of this command describes the parameters of the file system.
该命令的输出描述了文件系统的参数。
Highlights of the command and output are discussed.
我们将讨论高亮显示的命令及输出。
The command output indicates some logs located on the master and slaves.
命令输出指出主节点和从节点上的一些日志。
You can also use command assistance notifications to automatically save the command output.
您还可以使用命令帮助通知自动保存命令输出。
Figure 1 shows the typical output of a help command.
图1显示了典型的帮助命令的输出。
The output of the command for our setup is shown in Figure 1.
在我们的设置中命令的输出如图1所示。
The output of the command indicates the Map and Reduce process.
命令的输出说明映射和缩减过程。
Listing 10 shows the command being run and the output of the command.
清单10显示了需要运行的命令及其输出。
Listing 4 shows the program output from this command.
清单4展示了这一命令的程序输出。
The other output from the command is just for your information.
该命令的其它输出只是为您提供一些信息。
Listing 1 shows this command and its output.
清单1显示了这个命令以及输出。
Hence, the output of the command is a list of files that match.
因此，该命令的输出是匹配文件的列表。
The output of a command is a noun — data to be perused or used.
命令的输出是名词——要查阅或使用的数据。
Listing 1 shows typical output from this command.
清单1显示了此命令的典型输出。
Listing 1 shows the output from this command.
清单1显示了此命令的输出。
The command line console output is fairly simple.
命令行控制台输出相当简单。
Output of the command LLQ, on node ha2, after failover.
失效切换后，在节点ha2上llq命令的输出。
The command output is shown in listing 2.
命令输出如清单2所示。
Command-line output of sender application.
sender应用程序的命令行输出。
Command-line output of receiver application.
receiver应用程序的命令行输出。
Listing 7. Output of time command.
清单7.time命令的输出结果。
应用推荐