Exit Quick Mask mode and we have the selection of the shadow.
退出快速蒙版模式，我们得到了影子的选区。
Hit OK, and after the selection was made enter Quick Mask mode.
点击确认，出现选取后进入快速蒙版模式。
While in Quick Mask mode Control-click the thumbnail of the main character layer in the layers palette.
保持快速蒙版模式，同时在图层面板中，按住CTRL键点击那个包含了提取人物的图层的缩略图。
To go into 'quick mask mode', simply click on the right of the two buttons that are circled in red in the image below.
选择“快速蒙版模式”，只要点击在下图中被圈为红色的两个按钮的右边。
Create new file 1280 x 1024 px. Create a rectangular selection in the center of the image, hit Q to enter quick mask mode.
建立一张1280*1024的白底画布.然后在画布中间用选框工具建立一个矩形选区进入快速蒙版模式(Q).
Then set the layer to Overlay blending mode and use a mask to round off the corners.
然后将这个图层的混合模式设置为叠加，并用蒙版圆滑转角。
The mask can also be adjusted during the scan mode of operation using the same control keys.
面具还可以调整扫描期间的运作模式使用相同的控制键。
Set the blend mode to screen and use a mask to hide some areas of the fog we've just created.
设置混合模式为滤色，新建蒙版隐藏掉刚做好的雾气的某些部分。
Therefore, measurement of mode field diameter of single mode fibers by far-field mask is realized.
实现了用远场掩模法对单模光纤模场直径的测量。
Name this layer as "water texture" and right-click the layer, select "create clipping mask". Change the blending mode to "Overlay".
命名图层为水图层，点击右键-创建剪贴蒙板，图层模式-叠加。
Finally, the measurement of the chromatic dispersion of single mode fibers by mask method is realized.
最后，实现了掩模法对单模光纤色散的测量。
Set the blending mode to Overlay. With the brush tool, paint white in the mask where you want the correction to occur.
图层混合属性模式设置成覆盖，然后用画笔工具，选白色，然后去画想要去除紫边的区域。
Set the blending mode to Overlay. With the brush tool, paint white in the mask where you want the correction to occur.
图层混合属性模式设置成覆盖，然后用画笔工具，选白色，然后去画想要去除紫边的区域。
应用推荐