The gas temperature is estimated with 2000k.
估计的气体放电温度为2000 K左右。
This paper presents the self - made transient gas temperature transducer.
本文介绍了作者研制的瞬态气体温度传感器。
The flue gas temperature of direct-fired machine is too high to save energy.
直燃机排烟温度过高，不利于节能，在烟道上加设余热回收装置。
Reasons and harm of higher gas temperature at the final cooling stage are analyzed and solutions are proposed.
分析了终冷段煤气温度偏高的危害及原因，并提出了处理办法。
With the increase of the flue gas temperature, the efficiency of desulphurization showed a decreased tendency.
随烟气温度的升高，脱硫效率表现出减少的趋势。
Measurements were also conducted for the time-averaged gas temperature and species concentrations in the combustor.
同时还测量了该燃烧室内气体平均温度和组分浓度分布。
The magnitude of the turbulence then follows directly from the observed line with if the nebular gas temperature is known.
如果已知星云气体的温度，则湍流的大小可直接从观测的谱线宽度得出。
These methods have already been used for the gas temperature measurement at the exit of the high temperature rise combustor.
分析和比较了两种计算方法，这些方法已应用到燃烧室出口高温燃气温度测量中。
It deduced the way to do the temperature corrections in calculating calibration pressure when considering the gas temperature change.
考虑到气体温度变化，给出了对校准压力进行温度修正的方法。
Because of the pulsation of furnace gas temperature, it is impossible to measure the real gas temperature use normal three thermocouple.
由于炉内火焰温度存在波动，使得采用常规的三热电偶方法无法测定真实的烟气温度。
The distributions of gas temperature, O2, CO2, CO, and NO concentrations were measured under different swirl numbers for the primary air.
测量了在不同的一次风旋流数下，气体的时均温度、O2、CO2、CO和NO浓度的分布。
With some practical examples, this paper presents a general method to determine the extreme value of ideal gas temperature in arbitrarily process.
文章给出了求解理想气体任意过程温度最值的一种普遍方法，并且举例加以说明。
Flue gas temperature fuzzy control dimly deduces turndown ratio of mixer valve according to temperature values of multipoints and their variations.
烟气温度模糊控制根据系统多点温度值及其变化模糊推断混风阀的开度。
Now, in our nation power station, there is the large deviation between the actual exit flue gas temperature and the designed exit flue gas temperature.
由于炉膛出口烟温的偏差使我国许多电站锅炉的出力达不到额定值，因而直接影响到整个电厂的安全经济运行。
Predicted models of rising position of gas temperature, burn through point, vertical sintering speed, and so on, are established using dada analysis method.
采用数据分析的方法建立了废气温度上升点、烧结终点、垂直烧结速度等参数的预报模型；
Use several kinds of thermal calculation methods of boiler's furnace, and calculate the outlet flue gas temperature of a low load of some supercharged boiler.
运用几种热力计算方法，对某型船用增压锅炉低负荷工况的炉膛出口烟气温度进行了计算。
Electric Contact Bimetal thermometer is a site for low-temperature measurement instrumentation, can be used to directly measure the liquid, the gas temperature.
电接点双金属温度计是一种适合测量中低温的现场检测仪表，可用来直接测量液体、气体的温度。
An inverse calculation method is presented for determining the equivalent gray absorption coefficient of gases under various furnace gas temperature conditions.
提出了一种反演计算不同炉气温度下非灰气体的当量吸收系数的方法。
The increase in the fluctuation intensity of gas temperature will further enhance the instantaneous particle mass loss during the coal devolatilization processes.
随着气相温度脉动强度的增加，这种加快颗粒瞬时质量下降即挥发分释放的趋势更为明显。
The result shows that such factors as molar ratio of ammonia and CO2, concentration of hydrous ammonia, resident time and gas temperature influence CO2 absorption.
实验结果表明，氨与CO2的摩尔比、氨水浓度、停留时间和烟气温度等因素影响CO2吸收效率。
From the perspective of functional analysis, the prediction of the aeroengine exhaust gas temperature could be seen as a functional approximation problem in nature.
从泛函分析的角度出发，将航空发动机排气温度预测问题转换为一种泛函逼近问题。
The reduction of the engine exhaust gas temperature is one of the key points of this technology, which will influence the safe operation of the entire filter system.
在这一技术中，发动机的排气降温是关键环节之一，它直接影响到整个尾气微粒过滤系统的工作安全性。
By varying the loaded heat flux and wall emmisivity, the effect of gas temperature field and wall emmisivity on the equivalent gray absorption coefficient is studied.
通过调整供入的热负荷以及炉壁黑度，研究了炉壁黑度和炉气温度变化对反演的当量灰吸收系数的影响。
Studies the fuel kinds, the exit gas temperature of the hot air furnace, the excess air coefficient and the air moisture and temperature 'influence for waste heat loss.
研究了燃料种类、热风炉的排烟温度、过量空气系数以及燃烧空气湿度和温度对排烟热损失的影响规律。
Based on the experimental investigations, the influence of flue gas temperature on the precipitation properties of electrostatic precipitator was analyzed and discussed.
基于实验研究，分析讨论了含尘气流温度对无电晕式静电除尘器除尘性能的影响。
Temperature measurement principle and modulation absorption spectroscopy were introduced, and the influence of modulation amplitude on gas temperature measurement was analyzed.
介绍了温度测量及调制吸收光谱技术原理，分析了调制幅度对气体温度测量的影响。
The diameter of actual tangent circle is an important parameter for safety of boiler, the residual rotation is the key factor of flue gas temperature deviation at furnace exit.
实际切圆直径是锅炉稳定安全运行的一个重要参数，炉膛出口残余旋转是造成烟温偏差的主要原因。
The diameter of actual tangent circle is an important parameter for safety of boiler, the residual rotation is the key factor of flue gas temperature deviation at furnace exit.
实际切圆直径是锅炉稳定安全运行的一个重要参数，炉膛出口残余旋转是造成烟温偏差的主要原因。
应用推荐