• Using the average and the standard deviation, you can interpret that 68% of the attempts were between .2 and 1.3 seconds.

    使用平均值和标准偏差,您可以说明,68%的尝试是在 0.2秒到 1.3 秒之间。

    youdao

  • The average size is 3,131 square feet, with a standard deviation of 655 square feet. (Standard deviation is a statistical measure of variance.)

    平均大小为 3,131平方英尺,标准偏差为 655 平方英尺(标准偏差是一个描述差异的统计量度)。

    youdao

  • Measurement of sample: single sample automatic measuring, measuring the number of times 2, 3, 5, 10, 50 set, measured at the end gives the average value and standard deviation.

    样品测量:单样品自动测量,测量次数2、3、5、10、50次任意设定,测量结束给出平均值和标准偏差。

    youdao

  • The direct potentiometry for samples shows 100.9% of average recovery and 1.3% of standard deviation.

    用加入稀释法测定了回收率,平均回收率为100.9%,标准偏差为1.3%。

    youdao

  • The method to count standard deviation of indirect measurement value by using rear-average method was proposed.

    对用后均法进行测量数据误差分析加以探讨,提出可以用该法计算间接观测值的标准偏差。

    youdao

  • Furthermore, the average, variance and standard deviation are processed to testify the existence, occurrence stability and influence of each hypothetical role.

    进而得出每种假设角色的平均值,方差及标准差验证该假设角色的存在性、出现频率的稳定性以及对各个片断的影响程度。

    youdao

  • The first thing I did with this data was to calculate the average, minimum, maximum, and standard deviation of hours spent on each of twelve assignments.

    我对这资料做的第一件事是计算十二个作业中的每一个所花费的时间的平均值、最小值、极大值和标准差。

    youdao

  • The proposed statistical SS2M model has an average error of 4.16% with respect to SPICE Monte Carlo simulations, with an average error of standard deviation of only 3.06%.

    同时,提出的统计ss2 M模型与SPICE蒙特卡罗分析结果比较,均值的平均误差在4.16%以内,而方差的平均误差在3.06%以内。

    youdao

  • The effect of the applied stress magnitude on the average size of O phase is up to 106% and the size standard deviation of O phase increases considerably with applied stress increasing.

    外加应力大小对O相析出平均尺寸的影响可达106%,并且O相析出的尺寸标准差随外加应力增加而显著增大。

    youdao

  • Accuracy of the CT method was calculated as the average difference between methods. Precision was measured as the standard deviation of the CT measurement.

    以这两种方法间的平均差异来计算ct的准确性,以CT测量结果的标准差评估精确度。

    youdao

  • The distribution of grain diameter is narrow, wherein the standard deviation of the average granularity of the nickel sol grains is within 5%.

    粒径分布很窄,镍溶胶粒子的数均粒度的标准偏差在5%之内。

    youdao

  • The standard deviation, range, variation coefficient, 95% confidence interval were analyzed, the average values of 3 cycles were compared with those of 5 cycles.

    计算各组变异系数、标准差、极差、均数95%可信区间,比较连续3个心动周期与5个心动周期的参数测量值。

    youdao

  • Note: Uncertainty in table is showed by the square minus of the standard deviation from laboratory average data and sample unhomogeneity.

    注:表中不确定度以定值标准偏差和样品的不均匀方差表示。

    youdao

  • The analysis of measurement data error by using rear-average method was discussed. The method to count standard deviation of indirect measurement value by using rear-average method was proposed.

    对用后均法进行测量数据误差分析加以探讨,提出可以用该法计算间接观测值的标准偏差。

    youdao

  • The mean of post-test has improve by 8.6667 comparing to the pre-test, and the standard deviation of the post-test decreases, which implies students' average level improves.

    后测的分数明显高于前测的分数,后测平均分比前测平均分高出8.667分,而且后测的标准差小于前测,说明学生的整体水平有了提高;

    youdao

  • Results Total standard deviation of every solution was less than 5% of the concentration or detection limit. The confident limit of total average rate of recovery in sample kept in range of allowable.

    结果各种溶液测定的总标准差小于其浓度的5 %或检出限,总平均回收率可信限在允许范围内。

    youdao

  • Results Total standard deviation of every solution was less than 5% of the concentration or detection limit. The confident limit of total average rate of recovery in sample kept in range of allowable.

    结果各种溶液测定的总标准差小于其浓度的5 %或检出限,总平均回收率可信限在允许范围内。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定