焙烧，固体物料在高温不发生熔融的条件下进行的反应过程，可以有氧化、热解、还原、卤化等，通常用于无机化工和冶金工业。焙烧过程有加添加剂和不加添加剂两种类型。焙烧温度对焙烧过程很重要。
...焙烧温度 钯 二氧化钛 负载型催化剂 [gap=1312]Keywords】: terephthalic acid,p-carboxy benzaldehyde,hydropurification,calcination temperature,palladium,titanium dioxide,supported catalyst ..
基于40个网页-相关网页
学术vip_尖晶石CoFe2O4光催化还原CO2的研究 关键词：铁酸钴；光催化；二氧化碳；焙烧温度；焙烧时间 [gap=4684]Key words: CoFe2O4; photocatalysis; CO2; calcined temperature; calcined time
基于10个网页-相关网页
...英文版） 关键字: 氧化球团；焙烧温度；显微结构；还原速率；还原动力学[gap=1271]Key words: oxide pellets; roast temperature; microstructure; reduction rate; reduction kinetics...
基于10个网页-相关网页
The outcome indicates that when calcination temperature is higher than 500℃,catalytic activity reduced obviously.
结果表明当焙烧温度高于500℃时,催化剂活性明显降低。
参考来源 - 低浓度甲烷催化燃烧整体式催化剂的研究The results showed that when the calcinations temperature was 550℃and VOx loading was 12 wt.
VO_x/SiO_2催化剂的最佳制备条件是V2O5负载量为12 wt.%和焙烧温度为550℃。
参考来源 - VOThe most suitable pH value of the ion exchanged AgNO3 solution and ion exchanged temperature are 7.0 and 40℃ respectively, and the calcined temperature is 600℃.
催化剂制备最适宜的AgNO3离子交换溶液的pH值为7.0；离子交换温度为40℃；离子交换后焙烧温度为600℃。
参考来源 - 贫燃条件下汽车尾气净化催化剂The effects of calcined temperature and addition of Ce, Pr, K, Na or Cu elements on the complete combustion of toluene are investigated.
考察了催化剂的焙烧温度等因素对甲苯催化燃烧性能的影响。
参考来源 - 堇青石陶瓷蜂窝涂载非贵金属复合氧化物催化剂的VOCs催化燃烧性能研究·2,447,543篇论文数据，部分数据来源于NoteExpress
热失重结果表明，样品的失重率取决于焙烧温度。
The weightlessness rate of the sample depends mainly on its roasting temperature.
考察了活性组分含量和焙烧温度对催化剂活性的影响。
Influences of active component content and calcinations temperature were investigated.
研究了铬转化率与焙烧温度、配碱量、返渣氧化铜的量等条件的关系。
The relation. between the con- verting rate of chromium and roasting temperature , the amount of soda , the amount of back slag - copper oxide are also studied.
应用推荐