The influence of the joint form was analyzed, and the damping effects of the elastic joint were studied.
分析了沉管隧道管段连接方式对隧道动力特性的影响,研究了管段弹性连接减震效果;
Based upon the Lagrange's equation, the dynamic equation of the two robotic arms system with elastic joint has been established.
通过拉格朗日方程建立了考虑关节弹性变形的双连杆机械臂系统动力学方程。
Running, first floor to light, elastic, because if the feet heavily to the ground, the huge impact, knee joint in the long run will harm the legs.
跑步时,首先落地要轻,有弹性,因为如果脚重重地落到地上,对膝盖关节冲击力大,时间长了就会对腿造成伤害。
It illustrates that at the elastic stage this model can reflect the loading state of the joint.
这表明在弹性阶段,文中提出的模型能较好反映纵缝接头的受力状态。
According to the nonhomogeneous anisotropic elastic theory, a calculation model of the composite material plate with the circular hole in joint structures is set up.
本文针对连接结构中含圆孔的复合材料板,根据非均质各向异性弹性理论建立计算模型。
An exact elastic solution for the general case of a circular flange joint under tension loading is derived.
文中推导出一般情况下圆形螺栓法兰接头的弹性解,这一解可被应用于不同类型的接头上。
Based on classic elastic stability theory of framework, the four-moment equation and the stability equations of member group considering joint rigidity are derived and extended to study trusses.
在经典的刚架弹性稳定理论基础上推导了考虑节点刚度的四弯矩方程和构件群稳定方程,并将其应用于桁架结构。
Also the relationship between equivalent elastic modulus of discontinuous rock mass and connection rate of joint is studied with their influencing relation presented.
同时,研究了节理连通率与岩体等效弹性模量之间的影响关系,给出了二者的影响关系式。
According to the elastic theory, this paper gives partition Law of stress and quantitative answers over the overlap joint weld on skirted support.
利用弹性理论,分析推证出了裙式支座搭接焊逢内的应力分布规律及其定量解答。
The deformation of the structure will mainly concentrates at the joints when structural damage occurs. The timber members remain elastic while the joint steel plates yield.
破坏时结构变形主要集中在节点上,节点钢板达到屈服强度,而木构件处于弹性工作状态;
Results We got out the data of stretch ultimate load, maximum stress, maximum strain, elastic modulus on elbow joint ulnar nerve between control group and experimental group.
结果得出了对照组和实验组动物肘关节尺神经拉伸最大载荷,最大应力,最大应变,弹性模量等数据。
On the other hand, the recessing in the joint with low elastic modulus adhesive caus es the peak stresses increase evidently that may decrease the nominal and actual strength of the joint markedly.
而对于低弹性模量胶粘剂接头,间隙使得接头上的应力峰值明显上升,可能导致接头的名义强度和实际强度显著降低。
This paper gives a general equation for the ideal curve of crane beam with joint support, then further discusses the effect of elastic support on the curve, and gives the complement equation.
用能量法推导了刚性铰支大梁上拱和上翘曲线的一般方程。进一步探讨了弹性支座对上拱和上翘曲线的影响,并得出了相应的关系式。
It also presents a new type of prestressed elastic neoprene tube expansion joint used in highway decks.
文中着重介绍一种新型伸缩缝——预应力弹性胶管伸缩缝的构造、制作与安装以及试验和使用情况。
The effect of elastic modulus of adhesive on the str ess distribution in aluminium alloy single lap joint was investigated using elastic-plastic finite element method(FEM).
运用弹塑性有限元法,研究了胶粘剂弹性模量对含间隙的铝合金单搭接接头上应力分布的影响。
This paper presents a joint optimization model of time varying road tolls and capacities using the optimal control theory in disequilibrium traffic networks with elastic demand.
在可变需求网络中考虑交通流分配的非均衡演化过程,建立一个时变拥挤收费和道路通行能力的联合最优控制理论模型,旨在使系统的全期总收益最大。
The method, both for the tip trajectory and the elastic vibration control by a joint motor, was proposed.
提出了一种空间柔性结构通过关节电机同时实现轨迹控制和振动抑制的方法。
A link relation among two contacting surfaces and nonlocal elastic medium of joint interface was put forward.
给出了结合部非局部弹性介质与两接触表面的连接关系。
The results showed the path independence of J integral of welded joint. It established the foundation of application of elastic plastic J integral in welded structures.
计算结果表明了焊接接头中J积分的路径无关性,并为焊接结构中弹塑性J积分的应用奠定了基础。
The foundation of Baise gravity dam has bad geological phenomena such as high elastic modulus ratio, joint fissures and large faults etc.
百色重力坝地质条件复杂,地基岩体具有高模量比、节理裂隙发育等不良地质现象。
Bellows, a shell of wrinkled meridian of revolution, is commonly used as an elastic-sensitive element in aircraft meters, and a flexible joint in pipeline systems.
波纹管是一类子午线呈波纹状的旋转壳,作为弹性敏感元件和柔性连接件在航空仪表和管道工程中起着重要的作用。
With finite element method and compressed flexible array method, this paper establishes a method calculating displacement of joint slab on elastic foundation.
应用有限元压缩柔度矩阵,建立了具有接缝传荷能力多块板的位移计算方法。
Calculation of bolt group connection between hot-rolling channelbar and armor plate shows that nonlocal elastic medium's elastic parameters for joint interface are all time-varying.
热轧槽钢、钢板螺栓组连接的工程实例计算表明:结合部非局部弹性介质弹性参数皆为时变参数;
In this paper the governing equations of flexible manipulators are derived, which are nonlinear simultaneous differential equations of joint variables and link elastic modal coordinates.
本文给出了一般开链弹性机器人机构动力学方程。该方程是由关节广义坐标和杆件模态坐标联立的非线性微分方程组。
The elastic contact problem is analyzed in finite element method (FEM) and is used to the parameters' distribution and contact stress of the joint are obtained on the base of ANSYS code.
基于ANSYS软件平台求解弹性接触问题,获得了榫联接结构接触应力及接触状态量的分布;
The basic equations with Mohr-Coulomb criterion are solved by the line field analysis method near the joint line in an elastic-perfectly plastic materials.
通过在节理线上提出合理的边界条件,得出了节理线附近的弹塑性区应力场。
This joint is mainly comprised of elastic jaw, sliding sleeve and shear pin.
这种安全接头主要由弹力爪、锁套、滑套和剪钉组成。
In this paper, an outline of elastic-plastic and elastic-viscoplastic algorithm formulations for rock masses with three sets of joint is given, and some details about model tests are described.
本文扼要介绍了具有三组任意方位节理岩体的弹塑性和弹粘塑性有限元算法,给出了模型试验的某些细节。
Welding deformations of a pipe-plate joint with holes after multi-pass welding are simulated using the thermal-elastic-plastic finite element method.
采用三维热弹塑性有限元法对管板接头的焊接变形进行数值模拟。
Welding deformations of a pipe-plate joint with holes after multi-pass welding are simulated using the thermal-elastic-plastic finite element method.
采用三维热弹塑性有限元法对管板接头的焊接变形进行数值模拟。
应用推荐