模具结构中采用了定模强制脱模，顺序开模，滑动型芯延时顶出等机构。
Several mechanisms such as forced stripper, sequenced opening, delayed goring of the sliding core are applied in the design.
在侧抽芯机构中设计出一种顶出机构，改善塑件的成型质量，防止塑件脱模时的变形。
An ejection system was designed in the side core_pulling mechanism to improve the moulding quality and avoid deformation of the plastic part during demoulding.
为保证顺利脱模， 模具设计采用了双脱模机构，即定模采用杠杆、推杆顶出机构，动模采用推管二级顶出机构。
As a result, a mould with double stripper mechanism was needed, that is to say, there were levers and ejector pins on the stationary mould half and ejector pipes on the moving mould half.
应用推荐