过盈量是指基本尺寸相同的相互结合的孔和轴公差带之间的关系。决定结合的松紧程度。孔的尺寸减去相配合轴的尺寸所得的代数差为正时称间隙,为负时称过盈,有时也以过盈为负间隙。
中国造纸杂志社-造纸;纸浆;制浆;行业;专家;设备 关键词:高速纸机;设计;过盈量;铸钢辊 [gap=908]Key words: high speed paper machine; design; interference value; hollow steel rolls
基于86个网页-相关网页
...果;过盈量;有限元;厚度 [gap=523]Keywords: axial press-in-type pipe fitting;seal ability; magnitude of interference;the finite element;thickness ...
基于40个网页-相关网页
The research curve indicated that, static strength reliability is decreasing with the magnitude of interference value increasing, while anti-slide reliability is increasing with the magnitude of interference value increasing.
研究表明,静强度可靠度随着过盈量的增加而减小,而不滑移可靠度随着过盈量的增加而增大,也就是说,轮盘上的应力和过盈装配产生的摩擦扭矩随着弹性模量的增加而增大。
参考来源 - 大型离心压缩机叶轮可靠性研究In the same model, different interferences were considered. When the interference was 0.01mm, the maximum stress of bone was equal to the ultimate intensity.
同样,在上面的模型上分别设置六个不同的过盈量,利用界面最终的初始应力与骨的破坏强度相当的理论将计算得到界面处颌骨上的最大拉、压应力值与下颌骨的最大载荷极限做对比,得到本文中建立的微植体模型的最大过盈量为0.01mm。
参考来源 - 正畸微植入支抗的三维有限元应力分析及实验研究·2,447,543篇论文数据,部分数据来源于NoteExpress
汽车水泵轴承密封圈的密封性能与唇口过盈量密切相关。
The performance of automotive water pump bearing seal is closely related with the magnitude of interference of the sealing lip.
并对车轮车轴应力分布,飞轮离心力对紧固力过盈量的影响作了论述。
The stress distribution on wheel shaft and the effects of flywheel centrifugal force on its tight fit are discussed as well.
讨论了过盈量对模具寿命的影响,提出了几点提高模具寿命的合理化建议。
The effect of the interference on the die life was also discussed in the paper. Finally, some rationalization proposals were put forward for improving the die life.
应用推荐