...版、英文版） 关键字: 表面摩擦力; 轧制织构; 滑移系; 摩擦学参数[gap=425]Key words: surface friction force; rolling texture; slip system; tribology parameters...
基于102个网页-相关网页
The following are important results:（1）The finished alloy sheets of Al-Mg-Mn produced by cold roll and annealing for stabilization has {110}<112> rolling texture and {100}<001> cubic texture. The indexes of in-plane anisotropy of Al-Mg-Mn alloy sheet reduced by {100}<001> texture.
得到了以下重要结论:（1）Al-Mg-Mn合金冷轧-退火成品板材具有{110)<112>轧制织构和{100)<001>再结晶织构组态,立方再结晶织构的出现降低了Al-Mg-Mn合金的平面各向异性。
参考来源 - Al·2,447,543篇论文数据，部分数据来源于NoteExpress
结果表明，较低的铁素体轧制温度和较高的铁素体区压下量时，IF钢具有更高的深冲性能、相对较高的强度、延伸率以及织构强度。
The results showed that the if steel has better deep drawability, higher mechanical and texture strength and elongation if the hot rolling temperature was low with big reduction in ferrite region.
选取低硅无取向硅钢常化态板材，分别在不同速比下进行异步轧制，考察了速比对低硅无取向硅钢冷轧织构的影响。
The effect of speed ratio on the texture of non-oriented cold rolled low silicon steel sheet was investigated after cross shear rolling at different speed ratios.
本文系统地阐述了异步轧制剪切变形条件下板材冷轧织构的模拟计算理论；
The theory of calculating deformation texture on condition of cross shear rolling was introduced.
应用推荐