Based on the study mentioned above, a Pulsed Magnet Design Software (PMDS) package is developed using Visual Basic 6.0.
在以上工作基础上,作者研制了一套脉冲磁体分析设计软件(PMDS)。
参考来源 - 脉冲强磁体分析设计的理论与实践Theory analysis and experimental result show that the insulation demands of magnet cause its heat dissipation condition to be bad, so the cooling time of pulse magnet is general relatively long, it generally takes about 6 to 8 hours.
理论分析及实验结果表明,脉冲强磁场装置中磁体的绝缘性要求造成了其散热条件不良,所以脉冲磁体的冷却时间普遍较长,一般需要6到8小时左右,但磁体最内层和最外层的温度几乎一直维持在80K以下,而且最内层具有最大的温度变化率。
参考来源 - 70T脉冲强磁场磁体低温冷却模型与实验研究·2,447,543篇论文数据，部分数据来源于NoteExpress
该文叙述了30万高斯脉冲磁体杜瓦的设计及传热、漏热计算结果，LN2杜瓦的设计特点是做成两截的，这样装卸磁体方便。
This paper describes the design of the Dewal for 30t pulse magnet and the calculation result for transfering heat. The LN2 Dewar is in two sections, so the installation of the magnet is convenient.
采用经典电磁场、有限元数值计算两种方法，设计了一种用于磁热效应直接测量的脉冲螺线管磁体。
A pulsed solenoid magnet, which is applied for direct measurement of magnetocaloric, is designed by classical electromagnetic method and finite element numerical value calculation method.
本文第一次建立了在一个正弦型脉冲通过磁体期间考虑热效应时的瞬态电流方程。
In this article the equations of the instantaneous current, which take account of the thermal effect during a sine-shaped pulse current flowing in the magnet, are presented for the first time.
应用推荐