由于磨损引起的材料损失量称为磨损量,它可通过测量长度、体积或质量的变化而得到,并相应称它们为线磨损量、体积磨损量和质量磨损量。
... abrader 磨损试验机 abrasion 磨耗 abrasion loss 磨损量 abrasion resistance 耐磨能力 abrasion test 磨耗试验 ...
基于476个网页-相关网页
As a result, the friction factors of the samples after nitriding fall down and the wear extent decrease comparing with that of original samples. It is obvious that the low temperature nitriding process improve the abrasion-resistance of metal materials.
低温渗氮处理后的试样相比原始试样摩擦系数有所下降,磨损量减少,耐磨性大大提高。
参考来源 - 钢铁表面纳米化处理与低温气体渗氮研究②the wear mass loss of PDR increased with the improvement of load, which decreases firstly then enhances with the increase of velocity under the certain load.
②PDR的磨损量随载荷的增加而增加。
参考来源 - 润滑抗磨剂的耐磨延寿机理及其工程应用研究Carries on the theoretical analysis to the tentative data and the attrition appearance. The result indicates: The vibration affects the wear,the attrition quantity is not more but has a threshold with the vibration frequency higher in low frequency scope.
通过对试验数据和磨损形貌的理论分析,得到结论:振动工况对磨料磨损的影响不可忽视;在低频范围内,并非频率越高磨损量越大,而是有一个分界点。
参考来源 - 振动对磨料磨损影响的研究·2,447,543篇论文数据,部分数据来源于NoteExpress
磨损量与滑动摩擦功呈线性关系,与滑动距离成正比。
Mass loss is linear with sliding friction works and in proportion to sliding distances.
介绍了一种在线估算螺杆数控铣削中刀具磨损量的新方法。
New method for online tool wear estimation in spiral rod numerical controlled milling is presented.
低密度石墨的摩擦系数和体积磨损量比高密度石墨材料高。
The low density graphite gets higher friction coefficient and bulk worn loss than the high density graphite.
应用推荐