熔融温度是对于塑料、橡胶等材料而言的,实验室通常采用差示扫描量热仪(即DSC)进行测量。
大熔融温度(Melt Temperature Maximum):240℃ 最小熔融温度(Melt Temperature Minimum):180℃ 熔融温度(Melt temperature):235℃ 保压条件: 压力(PRES...
基于100个网页-相关网页
low temperature fusion 低温熔融 fusion temperature 熔化温度 ; 聚变温度 ; 熔融温度 ; 熔解温度 Temperature and Enthalpy of Fusion 熔融温度和焓 ..
基于60个网页-相关网页
... 温度;temperature 熔融温度;熔点;melting temperature 琼脂;冻粉;琼胶;洋菜;寒天;石花菜;Agar-agar ...
基于46个网页-相关网页
灰熔融温度 ash fusion temperature ; ash melting temperature
最小熔融温度 Melt Temperature Minimum
最大熔融温度 Melt Temperature Maximum
熔融温度和焓 Temperature and Enthalpy of Fusion
熔融温度指示器 fusible temperature indicator
起始熔融温度 incipient melting temperature
和熔融温度 Pyrometric Cone Equivalent
熔融结晶温度 melting crystallization temperature ; Melting-crystal temperature
Starch was pre-gelatinized and plasticized in order to destroy the crystal structure and reduce the melting temperature.
反应在本体熔融条件下进行,淀粉经过了糊化和增塑改性,以破坏其结晶结构和降低熔融温度。
参考来源 - 淀粉原位接枝丙交酯的研究After adding compatibilizer, the degree of crystallinity and melting point of PCL decreased further, and PCL also decreased the crystalline temperature of PBS in certain PCL content.
加入相容剂后,PBS使PCL结晶度及熔融温度下降的程度加大,PCL在一定范围内降低了PBS的结晶温度。
参考来源 - PBS及其共聚物的合成与表征The high temperature performance of Ti2AlN was investigated by high temperature microscope. The softening temperature of Ti2AlN was at the range of 1500℃—1580℃and its melting temperature was higher than 1700℃.
高温显微镜研究了单相Ti2AlN的高温行为,1500℃—1580℃温度范围是Ti2AlN材料的软化温度,其熔融温度大于1700℃。
参考来源 - Ti·2,447,543篇论文数据,部分数据来源于NoteExpress
它们的熔融温度比周围的树脂高。
They melt at a higher temperature than the surrounding resin.
配煤是降低煤灰熔融温度和灰渣粘度的有效手段之一。
The ash fusion characteristics and slag viscosity at different blending ratios were studied.
DSC研究表明辐照接枝产物的熔融温度和结晶温度均降低。
The DSC results showed both the melting temperature and crystallization temperature of the grafting products were decreased.
应用推荐