go top

气门间隙 [qì mén jiàn xì]

网络释义专业释义

  valve clearance

发动机配气机构液压挺柱介绍 液压挺柱介绍 一、 液压挺杆的功用 气门间隙valve clearance)是指发动机在冷状态下,当气门处于 ..

基于174个网页-相关网页

  Valve lash

... lash system 激光半主动寻的系统 ; 载驳船系统 Valve lash 气门间隙 lash eliminator 反冲击消除器齿轮齿隙消除器 ...

基于152个网页-相关网页

  valve stem clearance

... valve lash clearance adjustment 气门间隙调整 valve stem clearance 气门间隙 ; 气门杆导管间隙 valve bridge clearance 气门横梁间隙 ...

基于110个网页-相关网页

短语

调整气门间隙扳手 Tappet wrench

气门间隙调节垫片 Shim

气门间隙调节器 Valve Lash Adjuster

气门间隙调整螺钉 valve clearance adjusting screw ; Valve setting screw

气门间隙调整螺母 valve clearance adjusting nut ; TAPPET ADJUST NUT ; Valve setting nut

气门间隙调整 Valve-lash adjuster ; valve-lash control ; Ventilspielausgleich

气门间隙调整螺丝 TAPPET ADJUST SCREW

校气门间隙 check of the tappet clearance

 更多收起网络短语
  • valve clearance - 引用次数:18

    This paper presents that a satisfactory result both in the experiment and in the computer simulation will be obtained if a new kind of classifierwith neural network for identification of valve clearance of i. C. E is used.

    本文提出利用神经网络构成的分类器,对内燃机气门间隙进行识别,实验与计算机模拟,得到较满意的结果。

    参考来源 - 用神经网络对内燃机气门间隙的识别
  • valve clearance - 引用次数:9

    We changed the valve clearance to simulate the failure of engine. In the valve clearance and different rotate speed, we tested much vibration signal.

    实验通过人为调整气门间隙来模拟发动机气门间隙故障,并在各个气门间隙、不同的转速下测得了多组振动信号。

    参考来源 - 基于子带能量法的发动机振动信号分析研究
    valve lash
    valve stem clearance

·2,447,543篇论文数据,部分数据来源于NoteExpress

双语例句

  • 讨论了转速气门间隙落座影响

    The influence of engine speeds and valve gaps on the valve seating force has been examined.

    youdao

  • 由于液压挺杆自动调节气门间隙间隙同时降低发动机噪声

    Because the hydraulic valve plunger automatic control valve clearance is zero gap, simultaneously may reduce the engine noise.

    youdao

  • 汽车发动机气门间隙调整汽车使用维修经常进行一项重要作业

    It is an important work in automobile service and repair to adjust the valve clearance of engine.

    youdao

更多双语例句

百科

气门间隙

发动机工作时,气门将因温度的升高而膨胀。如果气门及其传动件之间在冷态下无间隙或间隙过小,则在热态下,气门及其传动件的受热膨胀势必引起气门关闭不严,造成发动机在压缩行程和做功行程中漏气,从而使功率下降,严重时甚至不易启动。为了消除这种现象,通常在发动机冷态装配时,在气门及其传动机构中留有一定的间隙,以补偿气门受热后的膨胀量。这一间隙称为气门间隙。

详细内容

以上来源于: 百度百科
$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定