文章摘要信息 关键词 ： 回弹 等弧长 模具补偿 冲压负角 [gap=1304]Keywords : springback;equal arc length;die compensation;stamping negative angle
基于20个网页-相关网页
即模具偏置补偿 Tool Componsation
A kind of die compensation strategy based on spring-back was presented in this chapter. And the program of flow chart of this method was given.
提出了基于回弹补偿的模具设计,介绍了模具补偿的方法和过程,并辅以例证。
参考来源 - 基于板材冲压成形回弹预示的模具补偿方法的研究·2,447,543篇论文数据，部分数据来源于NoteExpress
本文对普通拉延件的模具补偿进行了研究。
A die compensation strategy for general drawing parts is studied.
模具补偿是矫正复杂曲面冲压件回弹的有效方法，但它需要正确的回弹评价指导修模。
Mould compensation is an effective way to rectify the springback of complex surface sheet metal stamping, it needed an accurate springback evaluation to direct modifying die surfaces.
特别是LP02模具有良好的负色散值和能量分布，所以选用了LP02模作为高阶模补偿的模式。
Especially LP02 mode has huge dispersion and good energy distributing, so we choice LP02 mode as dispersion compensate.
应用推荐