...文网 关键词:钢筋混凝土粘结;拉拔试验;黏结单元;数值模拟 [gap=570]Keywords: reinforced concrete binding; Pull out tests; Bond unit; Numerical simulation ...
基于118个网页-相关网页
Design an indoor pullout test apparatus and a test project.
设计了室内拉拔试验设备和试验方案。
参考来源 - 土工格栅拉拔特性的试验研究By utilizing ANSYS common procedures for non-linear finite element analysis and in combinations of reasonable bond-slip constitutive relation and materials constitutive relation, it simulates the whole process of drawing test. The analysis results proved to coincide with the experimental results.
根据本文的粘结-滑移本构关系,利用ANSYS通用程序对试件进行了非线性有限元分析,以模拟拉拔试验的全过程,分析结果与试验结果吻合较好。
参考来源 - 内嵌加固时CFRP板条与混凝土粘结性能的研究And then, four kinds of bonding stability tests of asphalt material are taken, including slant shear test and direct pullout test.
本文接着对四种沥青材料进行界面结合稳定性试验,实验包括斜面剪切和直接拉拔试验。
参考来源 - OGFC防水粘结层材料性能研究·2,447,543篇论文数据,部分数据来源于NoteExpress
介绍了在保温板材与基层的粘结强度现场拉拔试验中粘结剂的选用。
Selection of adhesive for bonding strength fi eld pull-out tests of thermal insulation layer and substrate was introduced.
通过对69个试件的拉拔试验来探讨陶粒混凝土与变形钢筋之间的粘结锚固性能。
The bonding mechanism between deformed bar and lightweight concrete is discussed in this paper based on the pullout test results of 69 specimens.
本论文是通过对75个试件的拉拔试验来探讨陶粒混凝土与变形钢筋之间的粘结锚固性能。
The bonding mechanism between deformed bar and lightweight concrete is discussed in this paper based on the pullout test results of 75 specimens.
应用推荐