The open-loop control system is designed for the micro-feeding system and the control software is programmed too. The micro-feeding system is tested by experiments.
设计了微进给刀具系统的开环控制系统,编制了控制程序,并对微进给系统进行了实验研究。
参考来源 - 机床几何精度误差补偿技术的研究·2,447,543篇论文数据,部分数据来源于NoteExpress
针对宏微进给系统,利用弹性铰的微变形原理设计了宏微系统中的微动台。采用最小位能原理推导出一般弹性铰的二维刚度矩阵;
For the system of macro micro-feed table, a micro-feed table in macro-micro dual system was designed by using of flexure hinge.
通过静力分析得到了微进给刀具系统在静力作用下的变形和应力分布。
The stiffness and stress distribution of the micro-feeding system are obtained through static analysis.
本文介绍了作者最新研制的一种高精度压电陶瓷驱动微进给伺服控制系统,给出了系统的硬件组成及工作原理。
In this paper, a new micro-positioning servo control system using a piezoelectric. Actuator is introduced, the hardware consist and working principle are also given.
应用推荐