... 弯灯 swan-neck lamp 弯曲力 curve force (conductor rail) 完全接地 dead earthing ...
基于4个网页-相关网页
Through the calculation of the bending force and the checking of the strength, the processing feasibility of bending the plate along the width direction was analyzed. And the structure of the bending die and the attention points were stated.
通过弯曲力计算及强度校核,分析了此零件沿宽度方向弯曲的工艺可行性,并介绍了弯曲模的结构及注意事项。
参考来源 - 制动联板弯曲模 The Bending Die for the Brake Link Plate·2,447,543篇论文数据,部分数据来源于NoteExpress
主要的问题,与我的弯刹车是路线和位置的铰链在轴弯曲力。
The main problem with my bending brake was the alignment and position of the hinges in relation the axis of the bending edge.
套管弯曲力的定义不够严格,把弯曲力加到垂直井段是不正确的。
The definition of casing bend force is not exact, and taking the bend force into account for casing design in the vertical interval is not correct.
由于卸扣会使钻具产生弯曲力,因此,钻具接头必须尽可能低些坐在卡瓦上。
Since a bending force is exerted on the pipe during break out, the tool joint connection must be set in the slips as low as possible.
The force may taper off, the force may not be given by a straight line, but for modest deformations, every spring will have a linear regime in which the force is linearly proportional to the stretching.
它产生的力可能会渐渐消失,力的曲线可能不是一条直线,而有轻微的弯曲,每个弹簧都有一个线性区间,在这一区间内,力和伸长量是线性关系
应用推荐