成功实现此命令将创建如图9所示的表(与DB 2控制中心中显示的相同)。
Successful completion of this command will create the tables shown in Figure 9 (as displayed in the DB2 control center).
因此,在灾难数据中心中运行与主要数据中心相同的配置命令无法实现我们在本文中描述的灾难恢复解决方案。
As a result, running the same configuration commands in the disaster data center as you did in the primary data center will not give the disaster recovery solution we describe in this paper.
另外,在中心控制室设置了中心节点,中心节点可以接收网络中任何节点发送的数据,并对所接收到的数据进行分析,进而发出相应的控制命令,实现对整个系统的监控。
In addition, a central node set up in central control room can receive and analysis the data from any nodes on CAN-BUS. The instruction from the central node is sent for controlling system.
应用推荐