固溶 即固溶处理，是指固溶体凝固时，平衡转变受到抑制，得到亚稳态的过饱和固溶体单相组织的过程。
高Zn超高强铝合金的力学性能 - 中南大学学报（自然科学版、英文版） 关键字: 铝合金;均匀化;固溶;力学性能[gap=1204]Key words: aluminum alloy; homogenization; solution treatment; mechanical property
基于20个网页-相关网页
...关键字: 铝合金； 热处理； 固溶； 力学性能； 第二相[gap=1000]Key words: aluminum alloy; heat treatment; enhanced solution; mechanical properties; second phases...
基于8个网页-相关网页
固溶处理 solution ; solution heat treatment ; solid solution treatment
固溶化热处理 solution treatment
固溶强化 solid solution strengthening ; solution strengthening ; solution strength ; solid solution hardening
过饱和固溶体 supersaturated solid solution ; Over-saturated solid solution ; supersaturated structure
间隙固溶体 interstitial solid solution ; Zwischenmischkristall
加成固溶体 [物化] addition solid solution
置换固溶体 substitutional solid solution
固溶热处理 [机] solution heat treatment ; Solution Treatment ; solid solution heat treatment
固溶胶 solid
The changes of the Si phase morphology during the solution treatment were investigated.
研究了硅相在固溶处理过程中的变化规律。
参考来源 - 共晶AlCarrier concentration in room temperature increase with Sb amount increase,and reach the highest value when y=0.0125,then decrease with y further increase,. The results show that solid solubility of Sb in Mg_2Si_(0.6)Sn_(0.4) compounds is near y=0.0125.
室温载流子浓度随Sb掺入量增加先增加后减小,在y=0.0125获得最大值,表明Sb在Mg_2Si_(0.6)Sn_(0.4)化合物的固溶极限可能在y=0.0125附近。
参考来源 - n型Mg·2,447,543篇论文数据，部分数据来源于NoteExpress
结果发现，铜固溶在钨中，并形成了置换固溶体。
The results show that Cu solubilizes in W and the substitutional solid solution is formed.
对比测定了经固溶处理和未经固溶处理锯条的锯切性能。
The cutting performances of saw blade by solution and non-solution heat treating were determined.
重要的是较低的锻造温度和热处理固溶温度比较高的好得多。
It is important to control the forging temperature and solution treatment temperature lower rather than higher.
应用推荐