协同仿真(Collaborative Simulation)是一种处于不同地点、基于不同计算机平台的仿真人员采用不同建模方法建立混合异构层次化仿真模型,并在分布式环境上进行仿真运行、...
基于57个网页-相关网页
...龙源期刊网 关键词：Multisim；MCU Module；协同仿真；Keil；Proteus [gap=763]Keywords：Multisim;MCU Module;co-simulation;Keil;Proteus ...
基于50个网页-相关网页
Based on MPSP-Ⅱ, a design method of software and hardware co-simulation and verification environment is presented.
基于MPSP-Ⅱ平台,提出了一种软硬件协同仿真验证环境快速构建方法。
参考来源 - 可配置RISC核的设计及验证应用研究The co-simulation running based on HLA for the multi-disciplinary modeling based on HLA is proposed.
对应基于HLA的多领域建模，提出基于HLA的协同仿真运行。
参考来源 - 期刊学术社区·2,447,543篇论文数据，部分数据来源于NoteExpress
平顺性分析结果表明该协同仿真方法合理、可靠，满足非线性车辆模型的平顺性时域分析需要。
The results of ride analysis show that the co-simulation approach is reasonable and reliable and turns out to be adequate for time-domain ride analysis of a nonlinear vehicle model.
步进电机控制系统的开发采用了软硬件协同仿真的方法，可以有效地减少系统开发的周期和成本。
Stepper motor control system has been developed using the software and hardware co-simulation method, can effectively reduce the system development cycle and cost.
为了充分发挥仿真在MEMS设计中的作用，把协同设计的思想引入MEMS仿真中，提出了协同仿真的设计方式。
To enhance the effect of simulation on MEMS design, this paper introduces a collaborative design into MEMS design and proposes the collaborative simulation of MEMS.
应用推荐