n. parting
misc. mold splitting
All rights reserved Siemens PLM Software 分模(Parting ) -创建分模线和分模面 复杂分模线需要定义过渡段,被过渡段分隔开的各段分别产生分模 复杂分模线需要定义过渡段,被过渡段分隔...
基于52个网页-相关网页
·2,447,543篇论文数据,部分数据来源于NoteExpress
分模面应经过零件中心,而不要靠近上下边缘。
The parting surface should be through the center of the part, not near the upper or lower edges.
如果可能分模面应沿着单一平面,否则就顺着零件轮廓方向。
Parting surface should be along a single plane if possible, else following the contour of the part.
模具参数包括:分模面位置、飞边桥尺寸、中心连皮位置及厚度。
The die parameters included parting face position, bridge size, central slug position and thickness.
应用推荐