Three-Phase Fault（三相故障） 本组件用于在三相交流电路中生成故障。故障类型包括线对线和线对中性点，可对 每相的故障电流变量进行命名，如果需要的话还可以...
基于54个网页-相关网页
...如下设置： Three-Phase V-I Measurement Vabc Iabc A B C a b c 从线路元件库中选择三相电路短路故障发生器（Three-Phase Fault ），参数设置如下： 转换状态为[1 0] 转换时间为[0.05 0.4]，即 0.05秒故障，0.4秒故障切 除 缓冲电阻和缓冲电容都取 无穷大 Thr...
基于8个网页-相关网页
... three-phase exciter ==> 三相激磁器,三相励磁机 three-phase fault ==> 三相故障,三相事故 three-phase four core cable ==> 三相四芯电缆 ...
基于4个网页-相关网页
bolted three-phase fault 金属性三相短路故障 ; 完全三相短路故障
three phase fault 三相故障 ; 短路故障
balanced three phase fault 三相对称故障
three phase sustained fault 三相持续短路
three-phase three-line ground fault 三相三线地络故障
fault three phase 三相故障
three-phase ungrounded fault 三相非接地短路故障
three-phase symmetry fault 三相对称故障
three-phase grounding fault 三相接地短路
The analysis shows that the measured impedance at the head of the line is not proportional to the fault distance when a three-phase fault occurs at the end of the line.
分析表明，线路末端三相故障时，线路首端的测量阻抗不与故障距离成正比。
Stator phase failure is one typical fault of a three-phase induction motor.
缺相故障是三相感应电动机的典型故障之一。
The formulae for SMIS are derived and verified by case simulation, the solution of critical clearing time (CCT) of three-phase short fault in MMS is theoretically discussed.
对单机无穷大母线系统进行了公式推导和仿真验证，从理论上探讨了多机系统的三相短路故障临界切除时间求解方法。
应用推荐