To our best knowledge, static scheduling is adopt by most embedded systems.
目前多数嵌入式系统中采用仍是静态调度。
参考来源 - 基于嵌入式Linux的仪器操作系统的研究In this paPer, the research on static scheduling of FMC is based onsimulation by means of computer. In this paPer, modeling and scheduling of FMCare mostly discussed.
本文对FMC静态调度的研究是建立在计算机仿真基础上的。
参考来源 - 基于FMC作业调度仿真研究·2,447,543篇论文数据，部分数据来源于NoteExpress
Most job shop scheduling algorithms deal with static scheduling, but in reality the shop is dynamic.
目前多数作业车间调度算法考虑的是静态调度，但在实际生产中车间总是处于动态变化中。
The static scheduling with "Interrupt Affinity" is adopted to balance the load among processors, and to reduce the cache misses due to .
为此，采用“中断亲和”的静态调度方法来均衡处理器负载，并降低调度引起的高速缓存命中失败率。
Dynamic scheduling inevitably brings much overhead, however, it is very difficult to keep the load balance among processors if only static scheduling is used.
采用动态调度势必增加额外开销，纯采用静态调度又很难保证各处理器的负载平衡。
应用推荐