An example is a bolt hole circle, in which the diameter of the bolt circle, the spacing of thebolt holes, and other parameters must be specified.
例如螺栓孔圆形，螺栓圈的直径，其中必须指定螺栓孔和其他参数的间距。
If a maximum diameter is specified the tolerance shall be the total tolerance given in table 8 all under the maximum diameter.
如果指定了最大直径，公差应是表8中给出的总公差，所有的都低于最大直径。
This is a gauge to inspect whether the diameter of hole is larger than the specified MML or not , and this shall pass through the overall length of hole without any difficulty.
本量规用于检查孔的直径是否大于被规定的最大实体尺寸，要能够轻易的通过孔的全长。
应用推荐