... 瞬时辐射计 temporal radiometer 烧结时间 sintering time 胶原束状收缩 fasciculation of collagen ...
基于1个网页-相关网页
one-time sintering technology 一次性烧成
sintering holding time 烧结保温时间
one time sintering 一次烧结
long-time sintering 长时效烧结
When sintered at 1 420 ℃ for 5 min,the relative density reaches above 89%. With the extension of the sintering time,the relative density increases.
结果表明:烧结温度对液相烧结致密化起主要作用,W-20Cu复合粉末在液相烧结早期发生了显著的致密化,在1 420℃烧结5 min时,致密度可达到89%以上;随烧结时间的延长,致密度增加,在1 420℃烧结90 min时,相对密度最高,达到99.1%。
参考来源 - 超细/纳米WComplex impedance analysis indicates that the distribution of defects and pores,and the grain connected shapes at the grain-boundary tend to be more uniform and stable with proper extension of sintering time.2.
复阻抗谱分析说明,随着保温时间的延长使NiO粉体中的晶粒接触形态及缺陷和气孔分布等趋于均一和稳定。
参考来源 - NiO基气敏元件的制备及测试分析Increasing the sintering temperature and extending sintering time resulted in higher crystallinity and tap-density, but in a larger particle size.
升高烧结高温和延长烧结时间可使LiFePO4的晶体生长完好,结晶度提高,振实密度增大,但温度过高却会导致LiFePO4颗粒长大,电性能变差。
参考来源 - 碳热还原法磷酸铁锂的制备、结构与性能·2,447,543篇论文数据，部分数据来源于NoteExpress
The optimum sintering temperature, sintering time and proper heating-up rate were estimated in the meantime.
同时对最佳的烧成温度、烧成时间以及合理的升温速度作了预测。
The influence of the primary particle's size and the sintering time on the secondary particle was investigated.
分别研究了一次颗粒尺寸、烧结时间对于二次造粒的影响。
Hot pressed sintering can shorten sintering time and be beneficial to attain nano grain size sintering materials.
热压烧结可以缩短烧结时间，有利于获得晶粒保持纳米尺度的烧结体材料。
应用推荐