The circuit characteristics are analyzed. The simulation waveform and measurement result are given.
给出了仿真波形及实测结果。
参考来源 - 红外焦平面阵列读出电路设计It also analyzed the influence of the simulation parameters (pulsed frequency/assumed peak voltage/assumed base voltage) and the wire feeding speed on the simulation waveform.
本文还分析了脉冲参数(脉冲频率、设定峰值电压、设定基值电压)及送丝速度对仿真波形的影响。
参考来源 - 双丝脉冲MIG焊过程的动态仿真及试验验证·2,447,543篇论文数据，部分数据来源于NoteExpress
The output waveform of the module is the same figure as the simulation waveform. This result indicates that the design method is feasible.
基本驱动模块电路输出波形的测试结果表明，这种设计方法是完全可行的。
Then using the playback function of the testing system, it reads in the COMTRADE files and plays back simulation waveform and then begins to test the transformer protection.
然后利用试验系统的故障回放功能，读入生成的COM TRADE文件，回放仿真波形，对变压器保护装置进行试验。
The simulation results verify the high precision of the proposed compensation method regardless of the waveform of ct primary current, remanent flux level, and load characteristic.
仿真结果验证了所提补偿方法的高精度，而且不受CT负载特性、CT剩磁情况及原边电流直流成分的影响。
应用推荐