go top

ratio error

  • 比例误差

网络释义专业释义

  [数] 比率误差

... ratio controller 比率控制器 ratio differential relay 比率差动继电器 ratio error 比率误差 ...

基于326个网页-相关网页

  [数] 比例误差

... ratio controller 比例第器 ratio error 比例误差 raw data 原始数据 ...

基于174个网页-相关网页

  比值误差

...网 关键词:电流互感器;比值误差;相位误差;数学模型;测量不确定度 [gap=866]Key words: Current transformers; Ratio error; Phase displacement; Mathematical model; Measurement uncertainty ..

基于134个网页-相关网页

  比值差

比值差

基于1个网页-相关网页

短语

percent ratio error 变比误差百分数 ; 变比误差率

transfer ratio error [通信] 传送比率误差

PB ratio error 脉冲对条比错误

ratio error verification [电] 比值误差校验

current ratio error 变流比误差

bit error ratio 比特误差率 ; 误比特率 ; 误码率 ; 比特误码率

error ratio 误错比 ; 误差比 ; 误差率 ; 错误比

reference error ratio 参考差错率

ratio-error 比例误差

 更多收起网络短语
  • 比差 - 引用次数:6

    The electronic transformer can be checked by electronic transformer calibrator after analyzing experimental data, and meet the request of the 0.5% ratio error and 20' phase error.

    经过对实验数据的处理分析可知,校验仪对电子式互感器的校验精度满足0.5%的比差误差和20'的相位差。

    参考来源 - 基于FPGA的电子式互感器校验仪的研究
    比值误差 - 引用次数:3

    Finally, ratio error and phase error of electronic transducer are analyzed. Three algorithms can be used to calculate these errors and make compare reciprocally.

    文章最后分析了电子式互感器的比值误差和相位误差,提出了三种不同的计算方法,可用于相互验证。

    参考来源 - 基于以太网的电子式互感器校验方法研究
    比率误差
  • 比率误差
    比值误差
    比例误差
  • 比率误差

·2,447,543篇论文数据,部分数据来源于NoteExpress

双语例句

  • The ratio error of the divider calibration with this method is at 10-7 order magnitude.

    结果表明:方法校准分压箱比率误差10-7量级。

    youdao

  • Compensating reactor in a Capacitive Voltage Transformer (CVT) influences not on-ly its ratio error, but also the rated output capacity.

    电容式电压互感器(CVT)的补偿电抗器不但影响电压的准确度,而且影响额定容量。

    youdao

  • The influence of CT turn ratio to high impedance differential protection is analyzed, and the method of measuring turn ratio error is also introduced.

    分析CT[数]误差阻抗差动保护影响介绍了匝[数]比误差的测量方法

    youdao

更多双语例句
$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定