gradient phase morphology 梯度相形态
dispersed phase morphology 分散相形态的
two-phase morphology 两相结构
phase morphology control 相结构调控
Submicro phase morphology 亚微观相形态
separated phase morphology 分相形态
al fe phase morphology al3fe相形貌
If PTT is blended with PBT, the addition of PBT will influence melt viscosity. On the other hand, the introduction of PBT into PTT will certainly affect thermal behavior and phase morphology of the latter.
将二者共混,PBT的加入势必影响熔体的流动性能,另一方面PTT的热行为和相形态等势必受很大影响。
参考来源 - PTT及其PTT/PBT共混体系的热行为、凝聚态结构与流变性能研究The effects of irradiation on the structure and properties of blends were studied through characterizations of mechanical properties,phase morphology and gel content analysis.
通过对共混材料的力学性能、相态结构测和凝胶含量分析,对比研究了辐射对以上2种共混材料结构及性能的影响。
参考来源 - 氢化苯乙烯The results obtained by SALS were in agreement with SEM, therefore, method of on-line analysis by SALS may be feasible to study the phase morphology of polymer blends during twin-screw extrusion.
结果表明:小角激光光散射在线分析结果与在线取样的扫描电镜分析结果基本吻合,说明用小角激光光散射在线采集分析系统来研究双螺杆挤出过程中的相结构演变是可行的。
参考来源 - PP/POE共混体系在双螺杆挤出过程中的相结构演变研究·2,447,543篇论文数据，部分数据来源于NoteExpress
The double yielding was also found in some polymer blends with specific phase morphology, and the corresponding mechanism was suggested.
同时，发现在具有特殊相形态结构的聚合物及聚合物共混物中有二次屈服现象，并提出了相应的机理。
The concept of the model of energy ratio, which is an effective method to study phase morphology of immiscible polymer blends, was put forward.
指出了目前不相容聚合物共混体系相态反转数学模型的不足，提出了能量比模型的概念，认为这是研究不相容聚合物共混体系相态有效的方法。
For the blends with droplets phase morphology, the Izod impact strength and tensile strength increased when matrix ligament thickness decreased.
对于液滴状分散相共混物，共混物的缺口冲击强度和拉伸强度随着基体层厚度的降低而提高。
应用推荐