lower mould half 下半模 ; 下模
stationary mould fixed half 定模
half mould 半型
mould top half 上半型
mould the cope half 上箱造型
As a result, a mould with double stripper mechanism was needed, that is to say, there were levers and ejector pins on the stationary mould half and ejector pipes on the moving mould half.
为保证顺利脱模， 模具设计采用了双脱模机构，即定模采用杠杆、推杆顶出机构，动模采用推管二级顶出机构。
About half of all aluminium castings are made using high-pressure die-casting (HPDC), in which a molten aluminium alloy is injected under pressure into a steel mould, or die.
大约有一半的铸铝工艺是高压模铸(HPDC)，在这种工艺中，通过压力将液态铝合金注入钢模，或模具。
One half of the negative mould and the 'inside of the crankcase' mounted.
其中一半的负面模具和'内的曲轴箱'展开。
应用推荐