Bending stress status and destruction mechanism of stitching joint 3-D braided composites were also analyzed. There are two kinds of bending destruction modes and which are also influenced by lap length and stitching density.
不同的搭接长度和缝合密度对缝合连接三维编织复合材料试件的弯曲破坏模式有着很大的影响。
参考来源 - 缝合连接三维编织复合材料弯曲性能研究Lap length is a major parameter for continues purlin design. This dissertation advance a new lap length.
连续檩条的搭接长度也是设计中的一个重要的参数,本程序在分析的基础上提出了合理的搭接长度。
参考来源 - 冷弯薄壁连续檩条CAD系统的研究与开发·2,447,543篇论文数据，部分数据来源于NoteExpress
The strength can be increased with increasing lap width and decreasing lap length in the case of the same lap area.
与搭接面积呈线性关系，在搭接面积相同的情况下，可以通过增加搭接宽度减小搭接长度来增大接头强度；
The influence of length and position of recessing on the strength of adhesively bonded joints with different single-lap length was presented.
研究了间隙长度和间隙位置对不同单搭接接头强度的影响。
The results show that the data of shear strength are discrete. The main factor is the overflow dope that causes the lap length to be measured difficultly and the centerline disagree.
研究结果表明： 防热涂料的剪切强度分散性较大，这主要是由于溢胶现象使得搭接长度的准确测量比较困难，同时造成了试件的对中性较差。
应用推荐