的 gear data ，这些数据表示来自于一个制造过程(manufacturing process)中测量的齿轮直径( gear diameter)。这个程序的输出有意地设计为 NIST Handbook Example中所显示的DATAPLOT数据格式：
基于20个网页-相关网页
ring gear diameter 被动齿轮直径
Front gear diameter of spindle 主轴前轴承直径
gear pin diameter [机] 针齿直径
gear inside diameter measurement 齿轮内径测量
idler gear hub diameter 中间齿轮轮毂直径
Internal Gear Outside Diameter 内齿轮外径
maximum diameter of gear cut [机] 齿轮切削最大直径
inside diameter gear 内啮合齿轮
Usual plate gear have big diameter, but thin in depth, and have a axle hole in the center, so it can be simplified into a thin disc ring.
由于常用的盘形齿轮直径大，厚度小，且中间有较大的安装轴孔，所以可以将其简化为薄环盘，与变幅杆组成变幅器。
By analyzing, calculating and experimenting, it is shown that this precise shaping method of large module and large diameter internal meshing gear is better than any other methods.
通过分析计算及实验，结果表明，大模数大直径内啮合齿轮的这种精确成形方法比其它方法要好。
This article mainly introduces the method that adopts gear caliper to measure the median diameter normal tooth thickness of double-line trapezoidal thread.
本文主要介绍了采用齿轮卡尺测量双线梯形螺纹中径法向齿厚的方法，同时也测量出螺距产生的误差。
应用推荐